Re: Intel X58 eSATA port ?

Mike Tancsa wrote:
>> Don't you have any datasheet for this device?
> 
> No, its just a generic Intel branded board (Intel DX58SO)

I mean this Marvell chip.

>> Also a bit strange for me this messages:
>> ata0 at port 0x1f0-0x1f7,0x3f6 irq 14 on isa0
>> ata0: reset tp1 mask=00 ostat0=ff ostat1=ff
>> ata0: [MPSAFE]
>> ata0: [ITHREAD]
>> ata1 at port 0x170-0x177,0x376 irq 15 on isa0
>> ata1: reset tp1 mask=00 ostat0=ff ostat1=ff
>> ata1: [MPSAFE]
>> ata1: [ITHREAD]
>> channels 0 and 1 are legacy ATA channels. A bit strange to see them 
>> when AFAIK there is no PATA support on ICH10. If it is not a parts of 
>> Marvell, then I have no idea what is this.
> 
> Interesting, pciconf shows it as sata
> 
> 0[i7]# pciconf -lvc

> atapci1_at_pci0:0:31:2:    class=0x010601 card=0x4f538086 chip=0x3a228086 
> rev=0x00 hdr=0x00
>     vendor     = 'Intel Corporation'
>     class      = mass storage
>     subclass   = SATA
>     cap 05[80] = MSI supports 16 messages
>     cap 01[70] = powerspec 3  supports D0 D3  current D0
>     cap 12[a8] = SATA Index-Data Pair

ICH10 internal controller reported as AHCI capable SATA.

> atapci0_at_pci0:6:0:0:     class=0x01018f card=0x4f538086 chip=0x612111ab 
> rev=0xb2 hdr=0x00
>     vendor     = 'Marvell Semiconductor (Was: Galileo Technology Ltd)'
>     device     = '6121 SATA2 Controller'
>     class      = mass storage
>     subclass   = ATA
>     cap 01[48] = powerspec 2  supports D0 D1 D3  current D0
>     cap 05[50] = MSI supports 1 message
>     cap 10[e0] = PCI-Express 1 legacy endpoint

But Marvel reported as regular PATA

-- 
Alexander Motin