Re: de(4) does not work on 8.0-RC1

From: Kenyon Ralph <kenyon_at_kenyonralph.com>
Date: Tue, 6 Oct 2009 00:34:15 -0700
On 2009-10-05T23:22:53-0700, Kenyon Ralph <kenyon_at_kenyonralph.com> wrote:
> de0: <Digital 21140A Fast Ethernet> port 0xa400-0xa47f mem 0xf1000000-0xf100007f irq 23 at device 7.0 on pci2
> de0: can't read ENET ROM (why=-4) (ff7fffffffffffffffffffffffffffffffffffffffffffffffffffffffffffff
> de0: 21140A [10-100Mb/s] pass 2.2
> de0: address unknown
> 
> Also, ifconfig does not show de0.
> 
> FreeBSD ohm.kenyonralph.com 8.0-RC1 FreeBSD 8.0-RC1 #0 r197797: Mon
> Oct  5 21:40:16 PDT 2009
> root_at_ohm.kenyonralph.com:/usr/obj/usr/src/sys/KRZFSOHM  i386

Nevermind, I think this box has hardware problems. I plugged an Ethernet
cable into de0 and the system locked up hard after a few minutes. Now
the system won't even boot, even without the de0 card installed in the
PCI slot.

Kenyon
Received on Tue Oct 06 2009 - 05:34:18 UTC

This archive was generated by hypermail 2.4.0 : Wed May 19 2021 - 11:39:56 UTC