On Sunday 10 January 2010 4:30:13 am Rohit Grover wrote: > Hi Weongyo, > > On Sun, Jan 10, 2010 at 7:16 PM, Weongyo Jeong <weongyo.jeong_at_gmail.com> wrote: > > On Sun, Jan 10, 2010 at 06:41:21PM +1300, Rohit Grover wrote: > >> Hi, > >> > >> > Please try attached patch in bwn_probe() and show me dmesg output. ?If > >> > bwn(4) doesn't print anything that means ssb(4) works incorrectly. ?But > >> > there are some outputs and bwn(4) doesn't be attached then your device > >> > revision isn't supported. > >> > > >> > >> > >> After applying your patch, I get the following upon loading if_bwn: > >> > >> bwn0: vendor 0x4243 cid 0x812 rev 12 > >> > >> Therefore, I should infer that the device revision isn't supported? > > > > Yes it looks your revision isn't supported. > > > >> Do you know when this device might be supported? > > > > I think it could be supported when bwn(4) supports N PHYs I hope. > > Not being able to use the wireless hardware on my current laptop with > FreeBSD has caused me inconvenience to the point where I am seriously > contemplating the purchase of a new laptop. > Is there even a remote possibility that you may be able to estimate > when bwn(4) may be able to support such hardware? You might try ndis(4). I am using it for my Broadcom wireless card with an N- phy until bwn(4) supports my part natively. -- John BaldwinReceived on Mon Jan 11 2010 - 15:23:20 UTC
This archive was generated by hypermail 2.4.0 : Wed May 19 2021 - 11:40:00 UTC