Re: amd64 panic snd_hda - hdac_get_capabilities: Invalid corb size (0)

On Wed, Jul 28, 2010 at 07:33:44PM +0300, Andriy Gapon wrote:
> on 28/07/2010 19:17 Anton Shterenlikht said the following:
> > On Wed, Jul 28, 2010 at 07:07:34PM +0300, Andriy Gapon wrote:
> >> on 28/07/2010 19:01 Anton Shterenlikht said the following:
> >>> here it is:
> >> So did it work? :)
> > 
> > not as far as I can tell
> > 
> >>> % dmesg|fgrep -i hda
> >>> pci0: <multimedia, HDA> at device 20.2 (no driver attached)
> >>> pci0: <multimedia, HDA> at device 20.2 (no driver attached)
> >>> hdac0: <ATI SB600 High Definition Audio Controller> irq 16 at device 20.2 on pci0
> >>> hdac0: HDA Driver Revision: 20100226_0142
> >>> hdac0: [ITHREAD]
> >>> hdac0: hdac_get_capabilities: Invalid rirb size (0)
> >>> device_attach: hdac0 attach returned 6
> >> I presume the above is from previous load attempt?
> > 
> > yes, probably. I think /var/run/dmesg used
> > to contain only the current boot, but some
> > time ago I noticed that quite a few previous
> > boots are stored. Or maybe it's my misconfiguration..
> 
> Did you just kldload the module?
> Or do you have hda in your kernel and you performed a reboot?
> If you didn't reboot, can you do it now?

it's in the kernel, and yes, I did reboot.



> 
> So no corb message?
> This seems very strange, especially given the subject line.

But I just rebooted again, and reset
to defaults in BIOS, now I get:

% dmesg | fgrep -i hda
hdac0: <ATI SB600 High Definition Audio Controller> irq 16 at device 20.2 on pci0
hdac0: HDA Driver Revision: 20100226_0142
hdac0: [ITHREAD]
hdac0: hdac_get_capabilities: Invalid corb size (1)
device_attach: hdac0 attach returned 6


> 
> >> Also, no codec and pcm output lines?  Did the driver get attached?
> > 
> > As far as I can (cannot) see, the driver didn't attach.
> > There's no /dev/dsp or /dev/pcm.
> 
> What is output of the following command?
> kldstat -v | egrep 'sound|snd'

% kldstat -v | egrep 'sound|snd'
                139 sound
                138 pci/snd_hda
                137 hdac/snd_hda_pcm


thanks
anton

-- 
Anton Shterenlikht
Room 2.6, Queen's Building
Mech Eng Dept
Bristol University
University Walk, Bristol BS8 1TR, UK
Tel: +44 (0)117 331 5944
Fax: +44 (0)117 929 4423