Re: sparc64 r228561 panic: kmem_suballoc: bad status return of 3

Hi,

do you get your panic at early in the boot stage?

I get the same message on arm when I set the DEBUG_MEMGUARD flag early
on bootup:

Nov 24 201018:40:27
poweron_pll
EMI_CTRL 0x1C084040
FRAC 0x92926192
init_clock
init_ddr_mt46v32m16_133Mhz
exit self refresh timeout
power 0x00310710
Frac 0x92926192
start change cpu freq
hbus 0x00000003
cpu 0x00010001
KDB: debugger backends: ddb
KDB: current backend: ddb
Copyright (c) 1992-2011 The FreeBSD Project.
Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994
\0x09The Rege
nts of the University of California. All rights reserved.
FreeBSD is a registered trademark of The FreeBSD Foundation.
FreeBSD 10.0-CURRENT #948: Thu Dec 15 16:45:14 UTC 2011
root_at_bsd.ab:/usr/obj/arm.arm/usr/src/sys/ARM arm
WARNING: WITNESS option enabled, expect reduced performance.
WARNING: DIAGNOSTIC option enabled, expect reduced performance.
MEMGUARD DEBUGGING ALLOCATOR INITIALIZED:
\0x09MEMGUARD map base: 0xc0e8b000
\0x09MEMGUARD map lim
it: 0xc790b000
\0x09MEMGUARD map size: 109056 KBytes
CPU: ARM926EJ-S rev 5 (ARM9EJ-S core)
DC enabled IC enabled WB enabled LABT
16KB/32B 4-way Instruction cache
16KB/32B 4-way write-back-locking-C Data cache
real memory = 67108864 (64 MB)
panic: kmem_suballoc: bad status return of 3
KDB: enter: panic

br,

On Fri, Dec 16, 2011 at 9:40 AM, Anton Shterenlikht <mexas_at_bristol.ac.uk> wrote:
> Updating from r216048 to r228561 on sparc64,
> with sys/conf/newvers.sh changed to REVISION="9.9".
>
> Trinscribed by hand:
>
> FreeBSD 9.9-CURRENT #3 r228561M:
>
> panic: kmem_suballoc: bad status return of 3
> KDB: enter: panic
> [ thread pid 0 tid 0 ]
> Stopped at 0x02937e0:   ta    %xcc,1
> db>
>
> The keyboard froze, couldn't get a bt,
> required a cold reboot.
>
> My /etc/make.conf and kernel config files are below.
>
> Any advice?
>
> Many thanks
> Anton
>
>
>
>
> % cat /etc/make.conf
> # Add SMTP AUTH support to Sendmail
> SENDMAIL_CFLAGS+=   -I/usr/local/include -DSASL=2
> SENDMAIL_LDFLAGS+=  -L/usr/local/lib
> SENDMAIL_LDADD+=    -lsasl2
>
> # added by use.perl 2011-11-15 09:47:38
> PERL_VERSION=5.14.1
>
> % cat /root/kernels/QOF
>
> cpu             SUN4U           # work sparc64
> ident           QOF
>
> makeoptions     DEBUG=-g
> makeoptions     MODULES_OVERRIDE="geom/geom_part geom/geom_label opensolaris zfs"
>
> options         ALT_BREAK_TO_DEBUGGER
> options         BREAK_TO_DEBUGGER
> options         CD9660
> options         DDB
> #options        EXCEPTION_TRACING
> options         FFS
> options         GDB
> options         INET
> options         INET6
> options         INVARIANTS
> options         INVARIANT_SUPPORT
> #options        IPI_PREEMPTION
> options         KDB
> options         KTRACE
> options         MD_ROOT
> options         MSDOSFS
> options         NFSCLIENT
> options         NFSLOCKD
> options         P1003_1B_SEMAPHORES
> #options        PREEMPTION
> options         PRINTF_BUFR_SIZE=128
> options         PROCFS
> options         PSEUDOFS
> options         SCHED_4BSD
> #options        SCHED_ULE
> options         SCSI_DELAY=3000
> options         SCTP                    # Stream Control Transmission Protocol
> options         SOFTUPDATES
> options         SYSVMSG
> options         SYSVSEM
> options         SYSVSHM
> options         UFS_DIRHASH
> #options        UWX_TRACE_ENABLE
> options         WITNESS
> #options        WITNESS_KDB
> options         WITNESS_SKIPSPIN
> options         _KPOSIX_PRIORITY_SCHEDULING
>
> options         COMPAT_43TTY            # BSD 4.3 TTY compat (sgtty)
> options         STACK                   # stack(9) support
> options         HWPMC_HOOKS             # Necessary kernel hooks for hwpmc(4)
> options         KBD_INSTALL_CDEV # install a CDEV entry in /dev
>
> device          ata
> device          atadisk
> device          atapicd
> device          atapicam
> device          auxio
> device          bge
> device          bpf
> device          cd
> device          da
> device          ebus
> device          eeprom          # eeprom (really a front-end for the MK48Txx)
> device          ehci
> device          ether           # Ethernet support
> device          firmware        # firmware assist module
> device          isa
> device          loop            # Network loopback
> device          lpt
> device          machfb          # ATI Mach64 framebuffers
> device          mc146818        # Motorola MC146818 and compatible clocks
> device          md
> device          miibus          # MII bus support
> device          mk48txx         # Mostek MK48Txx clocks
> device          ohci
> device          pass
> device          pci
> device          pty             # BSD-style compatibility pseudo ttys
> device          puc             # Multi-channel uarts
> device          ppbus
> device          ppc
> device          random          # Entropy device
> device          rtc             # rtc (really a front-end for the MC146818)
> device          sbus
> device          sc
> device          scbus           # SCSI bus (required for SCSI)
> device          scc             # Serial communications controllers.
> device          snd_audiocs
> device          snd_t4dwave
> device          sound
> device          tun             # Packet tunnel.
> device          uart            # Multi-uart driver
> device          uhci
> device          ukbd            # Keyboard
> device          umass
> device          ums             # Mouse
> device          usb
>
> --
> Anton Shterenlikht
> Room 2.6, Queen's Building
> Mech Eng Dept
> Bristol University
> University Walk, Bristol BS8 1TR, UK
> Tel: +44 (0)117 331 5944
> Fax: +44 (0)117 929 4423
> _______________________________________________
> freebsd-current_at_freebsd.org mailing list
> http://lists.freebsd.org/mailman/listinfo/freebsd-current
> To unsubscribe, send any mail to "freebsd-current-unsubscribe_at_freebsd.org"



-- 
Monthadar Al Jaberi