Hi, We have a pack of identical Dell R610 mahcines with H200 cards. pciconf from R610 with FreeBSD9 on ZFS, disks in JBOD mode. mps0_at_pci0:3:0:0: class=0x010700 card=0x1f1e1028 chip=0x00721000 rev=0x02 hdr=0x00 vendor = 'LSI Logic / Symbios Logic' device = 'SAS2008 PCI-Express Fusion-MPT SAS-2 [Falcon]' class = mass storage subclass = SAS bar [10] = type I/O Port, range 32, base 0xfc00, size 256, enabled bar [14] = type Memory, range 64, base 0xdf2b0000, size 65536, enabled bar [1c] = type Memory, range 64, base 0xdf2c0000, size 262144, enabled cap 01[50] = powerspec 3 supports D0 D1 D2 D3 current D0 cap 10[68] = PCI-Express 2 endpoint max data 128(4096) link x4(x8) cap 03[d0] = VPD cap 05[a8] = MSI supports 1 message, 64 bit cap 11[c0] = MSI-X supports 15 messages in map 0x14 enabled We all aware of the state of things with the old mps driver, so I tried to pass a hardware array with the new one. Current snapshot from yesterday fails with following - http://oi40.tinypic.com/25gdw8o.jpg iirc, Dell has a nasty habit of writing its own firmware. On Thu, Jan 26, 2012 at 8:54 AM, Kenneth D. Merry <ken_at_freebsd.org> wrote: > On Wed, Jan 25, 2012 at 20:47:37 -0800, Dennis Glatting wrote: > > On Fri, 2012-01-20 at 13:44 -0700, Kenneth D. Merry wrote: > > > The LSI-supported version of the mps(4) driver that supports their 6Gb > SAS > > > HBAs as well as WarpDrive controllers, is available here: > > > > > > http://people.freebsd.org/~ken/lsi/mps_lsi.20120120.1.txt > > > > > > I plan to check it in to head next week, and then MFC it into stable/9 > a > > > week after that most likely. > > > > > > Please test it out and let me know if you run into any problems. > > > > > > In addition to supporting WarpDrive, the driver also supports > Integrated > > > RAID. > > > > > > Thanks to LSI for doing the work on this driver! > > > > > > > Does this include the SAS2008 series chips? I have two systems, one a > > Tyan FT48-B8812 with a S8812 MB and Interlagos chips, where I am > > interested in using a driver under 9.0 amd64. > > Yes. The driver in 9.0 supports the 2008 as well. > > Ken > -- > Kenneth Merry > ken_at_FreeBSD.ORG > _______________________________________________ > freebsd-current_at_freebsd.org mailing list > http://lists.freebsd.org/mailman/listinfo/freebsd-current > To unsubscribe, send any mail to "freebsd-current-unsubscribe_at_freebsd.org" >Received on Thu Feb 02 2012 - 12:48:29 UTC
This archive was generated by hypermail 2.4.0 : Wed May 19 2021 - 11:40:23 UTC