Hello, Swap was created twice on this 9.0 release candidate install- once as part of zfs and also as encrypted hard drive space. (30) _at_ 12:01:50> swapinfo Device 1K-blocks Used Avail Capacity /dev/zvol/bigD/swap 4194304 0 4194304 0% /dev/gpt/swap0.eli 3145728 0 3145728 0% /dev/gpt/swap1.eli 3145728 0 3145728 0% Total 10485760 0 10485760 0% Since then, all references to OpenBSD Packet Filter have been removed and the system is now r240891 ************************************************************* FreeBSD 10.0-CURRENT #1 r240891: Tue Sep 25 00:51:03 EDT 2012 WARNING: WITNESS option enabled, expect reduced performance. CPU: AMD Sempron(tm) Processor 2800+ (1599.86-MHz K8-class CPU) Origin = "AuthenticAMD" Id = 0x20fc2 Family = 0xf Model = 0x2c Stepping = 2 Features=0x78bfbff<FPU,VME,DE,PSE,TSC,MSR,PAE,MCE,CX8,APIC,SEP,MTRR,PGE,MCA,CM OV,PAT,PSE36,CLFLUSH,MMX,FXSR,SSE,SSE2> Features2=0x1<SSE3> AMD Features=0xe2500800<SYSCALL,NX,MMX+,FFXSR,LM,3DNow!+,3DNow!> AMD Features2=0x1<LAHF> real memory = 1073741824 (1024 MB) avail memory = 937144320 (893 MB ZFS NOTICE: Prefetch is disabled by default if less than 4GB of RAM is present; to enable, add "vfs.zfs.prefetch_disable=0" to /boot/loader.conf. ZFS filesystem version: 5 ZFS storage pool version: features support (5000) ipfw2 (+ipv6) initialized, divert loadable, nat loadable, rule-based forwarding disabled, default to deny, logging disabled DUMMYNET 0 with IPv6 initialized (100409) load_dn_sched dn_sched FIFO loaded load_dn_sched dn_sched PRIO loaded load_dn_sched dn_sched QFQ loaded load_dn_sched dn_sched RR loaded load_dn_sched dn_sched WF2Q+ loaded hpt27xx: no controller detected. GEOM_ELI: Device gpt/swap0.eli created. GEOM_ELI: Encryption: AES-XTS 128 GEOM_ELI: Crypto: software GEOM_ELI: Device gpt/swap1.eli created. GEOM_ELI: Encryption: AES-XTS 128 GEOM_ELI: Crypto: software warning: total configured swap (2621440 pages) exceeds maximum recommended amount (1852656 pages). warning: increase kern.maxswzone or reduce amount of swap. ************************************************************* Apparently kern.maxswzone is currently equal to 0. How might I tweak it just enough to fix this? Also, I have been disregarding the prefetch notice about zfs. I have not seen any adverse results. DarrelReceived on Thu Oct 04 2012 - 14:41:04 UTC
This archive was generated by hypermail 2.4.0 : Wed May 19 2021 - 11:40:31 UTC