Hi I can't figure out how to use rc.conf to configure my interfaces after these recent charges. My use case is that I have interfaces to configure but I don't need to put an IP address on them. I do need to change the MAC address though. What I have been doing is probably wrong, but it worked up until r252360: lagg0: link state changed to DOWN /etc/rc: WARNING: $ifconfig_lagg0_alias0 needs "inet" keyword for an IPv4 address. ifconfig: ether: bad value But, there is no ip address for this interface. The config looks like: cloned_interfaces="lagg0 \ vlan2 vlan3 vlan4 vlan5 vlan6 vlan7 vlan8 vlan9 vlan14 vlan15 vlan19 \ vlan20 vlan21 vlan22 vlan23 vlan24 vlan25 vlan26 vlan27 vlan30 \ vlan33 vlan37 vlan39 vlan40 vlan41 vlan44 vlan45 vlan999 \ " ifconfig_igb0="up" ifconfig_igb1="up" ifconfig_igb2="up" ifconfig_igb3="up" ifconfig_lagg0="up laggproto lacp laggport igb0 laggport igb1 laggport igb2 laggport igb3" ifconfig_lagg0_alias0="ether 00:1e:c9:53:3e:15" # Neotel ifconfig_vlan2="vlandev lagg0 vlan 2" #should probably be create_args ifconfig_vlan2_alias0="inet 41.161.56.4/29" ifconfig_vlan2_alias1="inet 41.154.2.106/29" ifconfig_vlan2_alias2="inet 196.46.25.156/25" ifconfig_vlan2_alias3="inet 41.161.56.2/29 vhid 2 pass XXXXXXX advskew 20" ifconfig_vlan2_alias4="inet 41.154.2.105/29 vhid 2 pass XXXXXXX advskew 20" ifconfig_vlan2_alias5="inet 196.46.25.155/25 vhid 2 pass XXXXXXX advskew 20" etc. I've tried create_args but I still get the following error: ifconfig: ether: bad value and, I cannot use ifconfig_lagg0 to set the MAC address because the rc system just seems to ignore the configured string. I can however 'ifconfig lagg0 ether 00:1e:c9:53:3e:15' from the cammand line, so there's something in the rc scripts that's mangling the argument. Ian -- Ian FreislichReceived on Sun Jun 30 2013 - 06:19:58 UTC
This archive was generated by hypermail 2.4.0 : Wed May 19 2021 - 11:40:39 UTC