On Nov 11, 2013, at 12:44 PM, Peter Grehan wrote: > Hi Devin, > >> Question: >> Does bhyve set kern.console irrespective of loader.conf values? > > The kernel sets it based on what it determines the console to be. Bhyve influences that by requesting a serial console. This is no different than booting on a headless machine with a serial console. > Well, for a headless meachine, I would set console=comconsole,vidconsole in loader.conf(5), then our Forth code slurps it in via loader.4th + support.4th routines... When boot is executed, I know I can see "kenv console", but hadn't realized that there were/are a host of others that are slurped into the kernel for later (very purposeful) fetching. So when you say that bhyve requests a serial console... I assume now it's setting variables... but via raw Forth? C code? loader.conf(5)? I've seen my menu come up under bhyve, and I noticed that it only has a 5-second count- down instead of the usual 9 -- but I'm curious how you're exporting the variables. -- Devin _____________ The information contained in this message is proprietary and/or confidential. If you are not the intended recipient, please: (i) delete the message and all copies; (ii) do not disclose, distribute or use the message in any manner; and (iii) notify the sender immediately. In addition, please be aware that any message addressed to our domain is subject to archiving and review by persons other than the intended recipient. Thank you.Received on Mon Nov 11 2013 - 19:52:28 UTC
This archive was generated by hypermail 2.4.0 : Wed May 19 2021 - 11:40:44 UTC