On Tue, 12 Nov 2013 00:34:24 +0100 dt71_at_gmx.com wrote: > Tijl Coosemans wrote, On 11/11/2013 10:07: >> On Sun, 10 Nov 2013 18:20:29 +0100 dt71_at_gmx.com wrote: >>> error: [drm:pid667:r100_cp_init_microcode] *ERROR* radeon_cp: Failed to load firmware "radeonkmsfw_R300_cp" >> >> Make sure you have /boot/kernel/radeonkmsfw_R300_cp.ko. > > Oops, my bad. I had WITHOUT_SOURCELESS=1 in /etc/src.conf. > > Now the said 3D application works, though the performance is crappier > than with the old Xorg... That could be because of this: info: [drm] Detected VRAM RAM=256M, BAR=256M info: [drm] RAM width 128bits DDR [TTM] Zone kernel: Available graphics memory: 257392 kiB [TTM] Initializing pool allocator info: [drm] radeon: 128M of VRAM memory ready info: [drm] radeon: 0M of GTT memory ready. info: [drm] radeon: 1 quad pipes, 1 Z pipes initialized. drmn0: warning: (-12) create WB bo failed drmn0: error: Disabling GPU acceleration info: [drm] radeon: cp finalized info: [drm] radeon: cp finalized [TTM] Finalizing pool allocator [TTM] Zone kernel: Used memory at exit: 0 kiB info: [drm] radeon: ttm finalized info: [drm] Forcing AGP to PCI mode It fails to use AGP. I have the same problem.Received on Tue Nov 12 2013 - 08:43:38 UTC
This archive was generated by hypermail 2.4.0 : Wed May 19 2021 - 11:40:44 UTC