On Sat, Jul 18, 2015 at 12:59:00AM +0000, Glen Barber wrote: > On Fri, Jul 17, 2015 at 05:52:58PM -0700, Kevin Oberman wrote: > > I just tried to install HEAD from the July 16 snapshot. Installation went > > fine using all defaults. (I am trying to test whether a problem with resume > > is present with HEAD.) > > > > I booted up the system from a USB drive with no problems until it tried to > > mount root. It simply sat "Waiting for /dev/da0p2" forever (or more than > > the 3 minutes I waited). System is a Lenovo ThinkPad T520 (amd64) that runs > > 10.2-BETA1 (r285359) without any issues other than the inability to resume/ > > > > da0 is an old 120GB USB drive and I can mount and examine it using either > > the install system or 10.2-BETA1 system. > > > > This is my first experience with HEAD since the release of 10.0. The boot > > looks quite normal and the UMASS and da0 devices show up and look normal. > > ugen1.3: <JMicron> at usbus1 > > umass0: <MSC Bulk-Only Transfer> on usbus1 > > umass0: SCSI over Bulk-Only; quirks = 0x4000 > > umass0:5:0:-1: Attached to scbus5 > > da0 at umass-sim0 bus 0 scbus5 target 0 lun 0 > > da0: <WDC WD12 00UE-00KVT0 3K01> Fixed Direct Access SCSI-2 device > > da0: Serial Number D578C6060290 > > da0: 40.000MB/s transfers > > da0: 114473MB (234441648 512 byte sectors: 255H 63S/T 14593C) > > da0: quirks=0x2<NO_6_BYTE> > > > > Would screen shots of the boot help? (I sure see anything unusual.) Is this > > a known issue? > > > > Yes, please provide screenshots. I did not observe this, although this > does not sound like a problem with the image(s), necessarily. > Also, just for science, can you also try the 10.2-BETA2 images that were uploaded today? Glen
This archive was generated by hypermail 2.4.0 : Wed May 19 2021 - 11:40:58 UTC