Hi to all FreeBSD community and developers! Sorry for my bad English... I am owner of mini-PC Intel NUC5PPYH and Intel DN2820FYKH. And both of NUCs has a problem with timer of BIOS start after FreeBSD installation and reboot/poweroff. FreeBSD 11.0-ALPHA2 (and the same problem with previous versions of FreeBSD). NUC5PPYH with latest BIOS 0054. NUC DN2820 with BIOS 0052. Computer is off. I am press Power button, NUC is on, and display graphical NUC logo and after a few seconds and one beeper sond (keyboard init) PC print menu. I am select boot from USB and install FreeBSD from USB-stick to HDD (Auto ZFS mode with GPT BIOS-active. <- working installer configuration for NUC). After reboot, then on case NUC5PPYH time from graphical logo "NUC" to beeper sound (keyboard init) is 1 min 15 sec, after that FreeBSD is loading. If Power Off PC and Power On again, the problem with slow start of BIOS to keyboard init is NOT solved. Workaround: Power Off and switch power off Power supply (APC SurgeArrest). And after that and Power On timer of BIOS start from NUC Logo to beeper sond (keyboard init) is a few seconds, after that FreeBSD is loading. But after FreeBSD # reboot/poweroff command problem is to repeat. But on DragonFlyBSD and Linux this problem is not observed on this computers. Is it possible to compare installation and reboot/poweroff procedure on FreeBSD and DragonFlyBSD and to find a solution to fix this problem on FreeBSD? best regards, Dmitry Postolov dip-freebsd_at_yandex.ruReceived on Fri Jun 10 2016 - 07:09:47 UTC
This archive was generated by hypermail 2.4.0 : Wed May 19 2021 - 11:41:05 UTC