Ian Lepore wrote on 03/26/16 02:11 AM: > On Fri, 2016-03-25 at 23:33 +0300, Ruslan Makhmatkhanov wrote: >> Hello, >> >> I have this in pciconf output: >> >> ===================================================================== >> = >> none1_at_pci0:36:0:0: class=0x088000 card=0x167e103c >> chip=0x2392197b >> rev=0x30 hdr=0x00 >> vendor = 'JMicron Technology Corp.' >> device = 'SD/MMC Host Controller' >> class = base peripheral >> >> none2_at_pci0:36:0:3: class=0x088000 card=0x167e103c >> chip=0x2393197b >> rev=0x30 hdr=0x00 >> vendor = 'JMicron Technology Corp.' >> device = 'MS Host Controller' >> class = base peripheral >> ===================================================================== >> = >> >> And my SD-card controller is not working anymore (it worked on >> -current >> on the same laptop year or two ago). Do I need to load some kld to >> make >> it working, or support for this controllers was dropped altogether >> for >> some reason? I have mostly vanilla GENERIC at r296772, but it >> actually >> stopped to work much earlier. >> >> Thanks. >> > > Do you have a pciconf entry for class=080501 chip=0x2391197b, device > would probably be "SD Host Controller", and if so, is it none_at_pci or > sdhci_pci_at_pci ? If sdhci_pci attached, there would be dmesg output for > it, and I'm curious whether any irq-related error showed up when it > attached. > > The only change I can find that might have some effect is a switch to > MSI-based interrupts some time ago. That was MFC'd to 10-stable in > r271051, and that's very close to range cited in that PR. > > It might be worth trying to set hw.sdhci.enable_msi=0 in loader.conf > and see if it makes a difference. > > -- Ian Sorry, but nothing has changed in pciconf/dmesg with this option at boot. -- Regards, Ruslan T.O.S. Of RealityReceived on Fri Mar 25 2016 - 22:42:19 UTC
This archive was generated by hypermail 2.4.0 : Wed May 19 2021 - 11:41:03 UTC