Den 2017-08-14 kl. 18:49, skrev Matt Joras: > On 08/14/2017 11:42, Panagiotes Mousikides wrote: >> I am working on the FreeBSD test suite, and need to create an image >> file from source. How can I do that? >> >> I need to run something similar to make installkernel && make >> installworld with an image file as the target, such that the end >> result is a ready-made FreeBSD system that can be started up with >> bhyve. How can I do that, including creating the correct /etc files, >> and the correct boot code and partitioning? >> > See release(7), https://www.freebsd.org/cgi/man.cgi?release(7). The > relevant section is under virtual machine disk images and the vm-image > target. The VMFORMATS for bhyve is "raw". That will generate an image > that "just works" with vmrun.sh > > Matt Joras > Hi Matt! Thank you so much for the tip! I tried what you recommended, the command I ran specifically was (inside release/) sudo make vm-image WITH_VMIMAGES=1 VMBASE=aaaa VMSIZE=2G VMFORMATS=raw VMSIZE=2G vm-image followed by sudo sh /usr/share/examples/bhyve/vmrun.sh -d aaaa.raw vm-aaaa but apparently the image generated doesn't work. The error I'm getting after hitting "1" at the boot screen is Error return from kevent monitor: Not permitted in capability mode repeatedly cascading through the screen. Any ideas? I would greatly appreciate your help! Best regards, PanagiotesReceived on Wed Aug 16 2017 - 10:57:31 UTC
This archive was generated by hypermail 2.4.0 : Wed May 19 2021 - 11:41:12 UTC