%cat /var/run/dmesg.boot 76.232.138 in via em0 panic: kmem_malloc(4096): kmem_map too small: 275251200 total allocated cpuid = 0; lapic.id = 00000000 boot() called on cpu#0 syncing disks, buffers remaining... 7154 7154 7153 7153 7153 7153 7154 7152 7152 7152 7152 7152 7152 7152 7152 7152 7152 7152 7152 7152 7152 7152 7152 7152 7152 7152 7152 Copyright (c) 1992-2003 The FreeBSD Project. Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994 The Regents of the University of California. All rights reserved. FreeBSD 5.1-RELEASE #0: Fri Jun 20 18:36:54 MDT 2003 root@srv2.ashleymadison.com:/usr/obj/usr/src/sys/SRV2 Preloaded elf kernel "/boot/kernel/kernel" at 0xc06ef000. Preloaded elf module "/boot/kernel/ipfw.ko" at 0xc06ef2e4. Preloaded elf module "/boot/kernel/acpi.ko" at 0xc06ef390. Timecounter "i8254" frequency 1193182 Hz Timecounter "TSC" frequency 2399328676 Hz CPU: Intel(R) Xeon(TM) CPU 2.40GHz (2399.33-MHz 686-class CPU) Origin = "GenuineIntel" Id = 0xf27 Stepping = 7 Features=0xbfebfbff Hyperthreading: 2 logical CPUs real memory = 4160225280 (3967 MB) avail memory = 4045828096 (3858 MB) Programming 24 pins in IOAPIC #0 IOAPIC #0 intpin 2 -> irq 0 Programming 24 pins in IOAPIC #1 Programming 24 pins in IOAPIC #2 FreeBSD/SMP: Multiprocessor System Detected: 4 CPUs cpu0 (BSP): apic id: 0, version: 0x00050014, at 0xfee00000 cpu1 (AP): apic id: 6, version: 0x00050014, at 0xfee00000 cpu2 (AP): apic id: 1, version: 0x00050014, at 0xfee00000 cpu3 (AP): apic id: 7, version: 0x00050014, at 0xfee00000 io0 (APIC): apic id: 2, version: 0x00178020, at 0xfec00000 io1 (APIC): apic id: 3, version: 0x00178020, at 0xfec80000 io2 (APIC): apic id: 4, version: 0x00178020, at 0xfec80400 Pentium Pro MTRR support enabled npx0: on motherboard npx0: INT 16 interface acpi0: on motherboard pcibios: BIOS version 2.10 Using $PIR table, 24 entries at 0xc00fde40 acpi0: power button is handled as a fixed feature programming model. Timecounter "ACPI-fast" frequency 3579545 Hz acpi_timer0: <24-bit timer at 3.579545MHz> port 0x1008-0x100b on acpi0 acpi_cpu0: on acpi0 acpi_cpu1: on acpi0 pcib0: port 0xcf8-0xcff on acpi0 pci0: on pcib0 IOAPIC #0 intpin 16 -> irq 2 IOAPIC #0 intpin 19 -> irq 10 IOAPIC #0 intpin 18 -> irq 11 pcib1: at device 2.0 on pci0 pcib1: could not get PCI interrupt routing table for \\_SB_.PCI0.HLB_ - AE_NOT_FOUND pci1: on pcib1 pci1: at device 28.0 (no driver attached) pcib2: at device 29.0 on pci1 pci2: on pcib2 IOAPIC #2 intpin 6 -> irq 16 IOAPIC #2 intpin 7 -> irq 17 em0: port 0x3000-0x303f mem 0xf8200000-0xf821ffff irq 16 at device 3.0 on pci2 em0: Speed:100 Mbps Duplex:Half em1: port 0x3040-0x307f mem 0xf8220000-0xf823ffff irq 17 at device 3.1 on pci2 em1: Speed:1000 Mbps Duplex:Full pci1: at device 30.0 (no driver attached) pcib3: at device 31.0 on pci1 pci3: on pcib3 IOAPIC #1 intpin 6 -> irq 18 asr0: mem 0xfc000000-0xfdffffff,0xfb000000-0xfbffffff,0xf8300000-0xf83fffff irq 18 at device 3.0 on pci3 asr0: major=154 asr0: ADAPTEC 2015S FW Rev. 3B05, 2 channel, 256 CCBs, Protocol I2O uhci0: port 0x2000-0x201f irq 2 at device 29.0 on pci0 usb0: on uhci0 usb0: USB revision 1.0 uhub0: Intel UHCI root hub, class 9/0, rev 1.00/1.00, addr 1 uhub0: 2 ports with 2 removable, self powered uhci1: port 0x2020-0x203f irq 10 at device 29.1 on pci0 usb1: on uhci1 usb1: USB revision 1.0 uhub1: Intel UHCI root hub, class 9/0, rev 1.00/1.00, addr 1 uhub1: 2 ports with 2 removable, self powered uhci2: port 0x2040-0x205f irq 11 at device 29.2 on pci0 usb2: on uhci2 usb2: USB revision 1.0 uhub2: Intel UHCI root hub, class 9/0, rev 1.00/1.00, addr 1 uhub2: 2 ports with 2 removable, self powered pcib4: at device 30.0 on pci0 pci4: on pcib4 pci4: at device 1.0 (no driver attached) isab0: at device 31.0 on pci0 isa0: on isab0 atapci0: port 0x2060-0x206f,0x374-0x377,0x170-0x177,0x3f4-0x3f7,0x1f0-0x1f7 mem 0xf8000000-0xf80003ff irq 0 at device 31.1 on pci0 ata0: at 0x1f0 irq 14 on atapci0 ata1: at 0x170 irq 15 on atapci0 pci0: at device 31.3 (no driver attached) acpi_button0: on acpi0 atkbdc0: port 0x64,0x60 irq 1 on acpi0 sio0 port 0x3f8-0x3ff irq 4 on acpi0 sio0: type 16550A, console sio1 port 0x2f8-0x2ff irq 3 on acpi0 sio1: type 16550A fdc0: port 0x3f7,0x3f0-0x3f5 irq 6 drq 2 on acpi0 fdc0: FIFO enabled, 8 bytes threshold fd0: <1440-KB 3.5" drive> on fdc0 drive 0 orm0: