Re: TESTERS WANTED for ATAng preview 1

On Fri, Aug 08, 2003 at 09:55:11PM +0200, Soeren Schmidt wrote:
> 
> The first preview release of ATAng is now available on:
> 
> ftp://ftp.deepcore.dk/pub/ATAng

    I cvsup'd to HEAD and applied the conf-patch and put in your
new ATA source, but when I recompiled my kernel and rebooted, the
server just locked up with the following dmesg:

Console: serial port
BIOS drive C: is disk0
BIOS 639kB/523264kB available memory

FreeBSD/i386 bootstrap loader, Revision 1.1
(wiz_at_test-server.lax1.tekgenesis.net, Mon Jun  9 08:51:01 HST 2003)
Loading /boot/defaults/loader.conf
/boot/kernel/kernel text=0x23b4b4 data=0x2700c+0x4cfd0 syms=[0x4+0x2f0a0+0x4+0x3a9c7]

Hit [Enter] to boot immediately, or any other key for command prompt.
Booting [/boot/kernel/kernel]...
Copyright (c) 1992-2003 The FreeBSD Project.
Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994
        The Regents of the University of California. All rights reserved.
FreeBSD 5.1-CURRENT #1: Fri Aug  8 13:41:50 HST 2003
    wiz_at_test-server.lax1.tekgenesis.net:/usr/obj/usr/src/sys/LEET
Preloaded elf kernel "/boot/kernel/kernel" at 0xc041b000.
Timecounter "i8254"  frequency 1193182 Hz
CPU: AMD Athlon(tm) XP 2100+ (1733.41-MHz 686-class CPU)
  Origin = "AuthenticAMD"  Id = 0x681  Stepping = 1
  Features=0x383fbff<FPU,VME,DE,PSE,TSC,MSR,PAE,MCE,CX8,APIC,SEP,MTRR,PGE,MCA,CMOV,PAT,PSE36,MMX,FXSR,SSE>
  AMD Features=0xc0400000<AMIE,DSP,3DNow!>
real memory  = 536870912 (512 MB)
avail memory = 517066752 (493 MB)
Pentium Pro MTRR support enabled
npx0: <math processor> on motherboard
npx0: INT 16 interface
pcibios: BIOS version 2.10
Using $PIR table, 14 entries at 0xc00f8030
pcib0: <Host to PCI bridge> at pcibus 0 on motherboard
pci0: <PCI bus> on pcib0
pci_cfgintr: 0:13 INTA BIOS irq 11
pci_cfgintr: 0:15 INTA BIOS irq 10
pcib1: <PCI-PCI bridge> at device 1.0 on pci0
pci1: <PCI bus> on pcib1
atapci0: <Promise PDC20376 SATA150 controller> port 0xe400-0xe47f,0xe800-0xe80f,0xec00-0xec3f mem 0xdffa0000-0xdffbffff,0xdffdf000-0xdffdffff irq 11 at device 13.0 on pci0
ata2: at 0xdffdf000 on atapci0
ata3: at 0xdffdf000 on atapci0
ata4: at 0xdffdf000 on atapci0
bge0: <Broadcom BCM5702 Gigabit Ethernet, ASIC rev. 0x1002> mem 0xdffc0000-0xdffcffff irq 10 at device 15.0 on pci0
bge0: Ethernet address: 00:10:dc:d6:05:a2
miibus0: <MII bus> on bge0
brgphy0: <BCM5703 10/100/1000baseTX PHY> on miibus0
brgphy0:  10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, 1000baseTX, 1000baseTX-FDX, auto
isab0: <PCI-ISA bridge> at device 17.0 on pci0
isa0: <ISA bus> on isab0
orm0: <Option ROM> at iomem 0xc8000-0xcffff on isa0
ata0 at port 0x3f6,0x1f0-0x1f7 irq 14 on isa0
ata1 at port 0x376,0x170-0x177 irq 15 on isa0
atkbdc0: <Keyboard cller (i8042)> at port 0x64,0x60 on isa0
sio0 at port 0x3f8-0x3ff irq 4 flags 0x10 on isa0
sio0: type 16550A, console
sio1 at port 0x2f8-0x2ff irq 3 on isa0
sio1: type 16550A
unknown: <PNP0c02> can't assign resources (port)
unknown: <PNP0501> can't assign resources (port)
unknown: <PNP0501> can't assign resources (port)
RTC BIOS diagnostic error 20<config_unit>
Timecounter "TSC"  frequency 1733405338 Hz
Timecounters tick every 10.000 msec
IPv6 packet filtering initialized, default to accept, unlimited logging
DUMMYNET initialized (011031)
ipfw2 initialized, divert enabled, rule-based forwarding enabled, default to accept, logging unlimited
IPsec: Initialized Security Association Processing.
ad6: 114473MB <WDC WD1200JB-00CRA1> [232581/16/63] at ata3-master UDMA100

(locked up at that point)

Thanks,

Jason