On Mon, 25 Aug 2003, Lars Eggert wrote: > Nate Lawson wrote: > >>this happens with an IBM MicroDrive mounted on a USB CF reader, -current > > > >>from 8/19/03. I couldn't get a coredump: > > > >>umass0: BBB reset failed, STALLED > >>(da2:umass-sim0:0:0:0): AutoSense Failed > >>umass0: BBB reset failed, STALLED > >>(da2:umass-sim0:0:0:0): AutoSense Failed > >>panic: softdep_setup_freeblocks: inode busy > >>da2 at umass-sim0 bus 0 target 0 lun 0 > >>da2: <SanDisk ImageMate II 1.30> Removable Direct Access SCSI-2 device > >>da2: 1.000MB/s transfers > >>da2: 1027MB (2104705 512 byte sectors: 255H 63S/T 131C) > > > > Your microdrive may need some USB quirks. Try RS_NO_CLEAR_UA (see > > /sys/dev/usb/umass.c for examples). > > Thanks, I'll try that. It also complains during boot about not > supporting Get Max Lun, so that's a quirk also. No, that's likely not a quirk. Complaining is ok if it doesn't cause actual problems (i.e. can't mount partition). Try one quirk at a time until it works. > Do you have any guesses what combination to use for the wire and command > protocol fields for this device? Copy a BBB line most likely. -NateReceived on Mon Aug 25 2003 - 13:02:37 UTC
This archive was generated by hypermail 2.4.0 : Wed May 19 2021 - 11:37:20 UTC