Nate Lawson wrote: >>>>umass0: BBB reset failed, STALLED >>>>(da2:umass-sim0:0:0:0): AutoSense Failed >>>>umass0: BBB reset failed, STALLED >>>>(da2:umass-sim0:0:0:0): AutoSense Failed >>>>panic: softdep_setup_freeblocks: inode busy >>>>da2 at umass-sim0 bus 0 target 0 lun 0 >>>>da2: <SanDisk ImageMate II 1.30> Removable Direct Access SCSI-2 device >>>>da2: 1.000MB/s transfers >>>>da2: 1027MB (2104705 512 byte sectors: 255H 63S/T 131C) >>> >>>Your microdrive may need some USB quirks. Try RS_NO_CLEAR_UA (see >>>/sys/dev/usb/umass.c for examples). RS_NO_CLEAR_UA doesn't seem to help: umass0: BBB reset failed, STALLED (da2:umass-sim0:0:0:0): AutoSense Failed initiate_write_filepage: already started initiate_write_filepage: already started initiate_write_filepage: already started It hasn't crashed yet, but solme funky things are going on. >>Thanks, I'll try that. It also complains during boot about not >>supporting Get Max Lun, so that's a quirk also. > > No, that's likely not a quirk. Complaining is ok if it doesn't cause > actual problems (i.e. can't mount partition). Try one quirk at a time > until it works. OK. Lars -- Lars Eggert <larse_at_isi.edu> USC Information Sciences Institute
This archive was generated by hypermail 2.4.0 : Wed May 19 2021 - 11:37:20 UTC