Have you installed the world? I don't know if just rebuilding it is sufficient.... To install the world you have to go to single user mode and run mergemaster to update any changes in configuration files (take a backup of your current files as it overwrites them). Anthony On Monday 31 March 2003 13:15, Ventsislav Velkov wrote: > Hello all, > > I have a problem updating one of our servers from 4.7Stable to 5.0Current. > It is a Compaq Proliant 7000 Server with 4 Xeons _at_500Mhz with 2MB L2 cache > each. I has a 4200 Compaq Smart Raid Controler with attached 3 U1 Storages. > I update the src rebuild the world from updated src to 5.0Current, build a > GENERIC kernel and installed it. But after I boot it brokes up during the > booting process with the following error: > > //strip > > Fatal trap 12: page fault while in kernel mode cpuid=0; lapic.id= 01000000 > fault virtual address = 0x54 > fault code = supervisor read, page not present > .... > .... > .... > process eflags = interrupt enabled, resume, IOPL=0 > current process = 4(g_down) > kernel: type12trap, code=0 > Stopped at ida_construct_qcb+0xe3: movzbl 0x54(%eax),%eax > > //strip > > It may have some punctual mistakes because it is not a copy/paste. > > Will appreciate any advices where could be the problem. > > Best regards, > > Veno > _______________________________________________ > freebsd-current_at_freebsd.org mailing list > http://lists.freebsd.org/mailman/listinfo/freebsd-current > To unsubscribe, send any mail to "freebsd-current-unsubscribe_at_freebsd.org"Received on Mon Mar 31 2003 - 02:10:08 UTC
This archive was generated by hypermail 2.4.0 : Wed May 19 2021 - 11:37:02 UTC