In -current as of midday (EST) 12/12/04: acpi_tz0: _AC2: temperature 78.0 >= setpoint 55.0 acpi_tz0: _AC1: temperature 78.0 >= setpoint 70.0 ata1-slave: FAILURE - ATAPI_IDENTIFY timed out ata1-slave: FAILURE - ATAPI_IDENTIFY timed out ata1-slave: FAILURE - ATAPI_IDENTIFY timed out ata1-slave: FAILURE - ATAPI_IDENTIFY timed out acd0: FAILURE - SETFEATURES SET TRANSFER MODE timed out acd0: CDRW <UJDA740 DVD/CDRW/1.20> at ata1-master UDMA33 Fatal trap 12: page fault while in kernel mode fault virtual address = 0xff012b fault code = supervisor read, page not present instruction pointer = 0x8:0xc0440ea9 stack pointer = 0x10:0xc0c20c30 frame pointer = 0x10:0xc0c20c58 code segment = base 0x0, limit 0xfffff, type 0x1b = DPL 0, pres 1, def32 1, gran 1 processor eflags = interrupt enabled, resume, IOPL = 0 current process = 0 (swapper) [thread pid 0 tid 0 ] Stopped at xpt_compile_path+0x49: cmpl %edx,0x2c(%eax) db> trace Tracing pid 0 tid 0 td 0xc07a1320 xpt_compile_path(0,1,0,c1e21000,c1e21800) at xpt_compile_path+0x49 xpt_create_path(c0c20cb0,c1b29d80,0,1,0) at xpt_create_path+0x4d xpt_scan_bus(c1b29d80,c1e21800,c1c3b5a0,c1e1f000,c0c20d48) at xpt_scan_bus+0x20b xpt_action(c1e21800,c1e21800,1,ffffffff,ffffffff,c1c3b5a0) at xpt_action +0x423 xptconfigfunc(c1e1f000,0,0,c1b218d0,c1b21904) at xptconfigfunc+0xf6 xptbustraverse(c0c20d48,0,c0444ab0,0,c1b218d0) at xptbustraverse+0x23 xpt_for_all_busses(0,c054d367,c07a39ac,3e8,c054d330) at xpt_for_all_busses+0x25 run_interrupt_driven_config_hooks(0,0,c1b21904,c1ec00,c1e000) at run_interrupt_driven_config_hooks+0x22 mi_startup() at mi_startup+0xbb begin() at begin+0x2c removing 'device atapicam' from kernel config got me a working kernel. If there is need for additional information or patch to test, I will be glad to oblige. -- Alexandre "Sunny" Kovalenko (Олександр Коваленко)Received on Mon Dec 13 2004 - 01:29:20 UTC
This archive was generated by hypermail 2.4.0 : Wed May 19 2021 - 11:38:24 UTC