Looks like i have found a problem. When i disable hints file in the kernel config - everything become fine and i can now see my cd0 perfectly :) Thanks everybody. Regards, Anton Anton Nikiforov пишет: > Kevin Oberman пишет: > >>> Date: Fri, 12 Mar 2004 22:45:11 +0300 >>> From: Anton Nikiforov <anton_at_nikiforov.ru> >>> Sender: owner-freebsd-current_at_freebsd.org >>> >>> This is a cryptographically signed message in MIME format. >>> >>> --------------ms080000060000010305090003 >>> Content-Type: text/plain; charset=ISO-8859-5; format=flowed >>> Content-Transfer-Encoding: 7bit >>> >>> Hello and thanks, >>> Before writing here i ave read it and for sure i have had all needed >>> devices in the kernel. >>> # ATA and ATAPI devices >>> device ata >>> device atadisk # ATA disk drives >>> device atapicd # ATAPI CDROM drives >>> device atapifd # ATAPI floppy drives >>> device atapist # ATAPI tape drives >>> device atapicam >>> options ATA_STATIC_ID #Static device numbering >>> # SCSI peripherals >>> device scbus # SCSI bus (required) >>> #device ch # SCSI media changers >>> device da # Direct Access (disks) >>> #device sa # Sequential Access (tape etc) >>> device cd # CD >>> device pass # Passthrough device (direct SCSI >>> access) >>> #device ses # SCSI Environmental Services (and >>> SAF-TE) >>> >>> >> >> What does the dmesg look like? Is it not listing cd0? You should see at >> least on line for cd0 right after the acd0 lines near the end of the >> output. The first should be: >> cd0 at ata1 bus 0 target0 lun 0 >> >> This should be followed by (at least) on more line reporting the >> details of the drive: manufacturer, model, version >> >> Are these showing up? >> >> > No. And this is a problem and question. That cd0 is not showing. > > Regards, > Anton
This archive was generated by hypermail 2.4.0 : Wed May 19 2021 - 11:37:47 UTC