Tyler Gee wrote: >Do you have miibus in the kernel still? > > Don't remember if it was needed for bfe driver. Normally I disable everything unused. Will check later. Thanx Rob > >On Thu, 30 Sep 2004 12:08:55 -0700, Rob <rob_at_pythonemproject.com> wrote: > > >>I didn't see a wifi mailing list, so thought I would ask here, where the >>real experts hang out ;) >> >>I am tired of having to log into windoze in order to access my network >>over wifi. I think this would be much easier if I wasn't using a notebook. >> From reading the handbook it appears that the process will take some >>doing, since I need wifi plus cardbus. >> >>Problem seems to be right now that my Netgear WG511T cardbus card >>doesn't seem to be reconginized. >> >>wi, cardbus, pcmcia, and the bridge are all compiled into my kernel. >>Possibly a couple other related devices. >> >>I have attached my dmesg. Any hints would be appreciated. >> >>Thanks, Rob >> >> >> >>Copyright (c) 1992-2004 The FreeBSD Project. >>Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994 >> The Regents of the University of California. All rights reserved. >>FreeBSD 5.3-BETA5 #0: Sun Sep 19 03:04:23 PDT 2004 >> rob_at_lm741n.dyndns.org:/usr/obj/usr/src/sys/ROBKERN >>WARNING: WITNESS option enabled, expect reduced performance. >>Timecounter "i8254" frequency 1193182 Hz quality 0 >>CPU: Intel(R) Pentium(R) M processor 1700MHz (1698.57-MHz 686-class CPU) >> Origin = "GenuineIntel" Id = 0x695 Stepping = 5 >> Features=0xa7e9f9bf<FPU,VME,DE,PSE,TSC,MSR,MCE,CX8,SEP,MTRR,PGE,MCA,CMOV,PAT,CLFLUSH,DTS,ACPI,MMX,FXSR,SSE,SSE2,TM,PBE> >>real memory = 1073405952 (1023 MB) >>avail memory = 1040867328 (992 MB) >>npx0: [FAST] >>npx0: <math processor> on motherboard >>npx0: INT 16 interface >>pcib0: <Host to PCI bridge> pcibus 0 on motherboard >>pir0: <PCI Interrupt Routing Table: 9 Entries> on motherboard >>$PIR: BIOS IRQ 11 for 0.29.INTB is not valid for link 0x63 >>$PIR: BIOS IRQ 11 for 2.1.INTA is not valid for link 0x63 >>pci0: <PCI bus> on pcib0 >>agp0: <Intel 82855 host to AGP bridge> mem 0xe0000000-0xe7ffffff at device 0.0 on pci0 >>pcib1: <PCIBIOS PCI-PCI bridge> at device 1.0 on pci0 >>pci1: <PCI bus> on pcib1 >>pci1: <display, VGA> at device 0.0 (no driver attached) >>uhci0: <Intel 82801DB (ICH4) USB controller USB-A> port 0xbf80-0xbf9f irq 11 at device 29.0 on pci0 >>uhci0: [GIANT-LOCKED] >>usb0: <Intel 82801DB (ICH4) USB controller USB-A> on uhci0 >>usb0: USB revision 1.0 >>uhub0: Intel UHCI root hub, class 9/0, rev 1.00/1.00, addr 1 >>uhub0: 2 ports with 2 removable, self powered >>uhci1: <Intel 82801DB (ICH4) USB controller USB-B> port 0xbf40-0xbf5f irq 11 at device 29.1 on pci0 >>uhci1: [GIANT-LOCKED] >>usb1: <Intel 82801DB (ICH4) USB controller USB-B> on uhci1 >>usb1: USB revision 1.0 >>uhub1: Intel UHCI root hub, class 9/0, rev 1.00/1.00, addr 1 >>uhub1: 2 ports with 2 removable, self powered >>uhci2: <Intel 82801DB (ICH4) USB controller USB-C> port 0xbf20-0xbf3f irq 11 at device 29.2 on pci0 >>uhci2: [GIANT-LOCKED] >>usb2: <Intel 82801DB (ICH4) USB controller USB-C> on uhci2 >>usb2: USB revision 1.0 >>uhub2: Intel UHCI root hub, class 9/0, rev 1.00/1.00, addr 1 >>uhub2: 2 ports with 2 removable, self powered >>pci0: <serial bus, USB> at device 29.7 (no driver attached) >>pcib2: <PCIBIOS PCI-PCI bridge> at device 30.0 on pci0 >>pci2: <PCI bus> on pcib2 >>bfe0: <Broadcom BCM4401 Fast Ethernet> mem 0xfaffe000-0xfaffffff irq 11 at device 0.0 on pci2 >>miibus0: <MII bus> on bfe0 >>bmtphy0: <BCM4401 10/100baseTX PHY> on miibus0 >>bmtphy0: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto >>bfe0: Ethernet address: 00:0d:56:38:b8:a0 >>bfe0: [GIANT-LOCKED] >>cbb0: <TI4510 PCI-CardBus Bridge> irq 11 at device 1.0 on pci2 >>cardbus0: <CardBus bus> on cbb0 >>pccard0: <16-bit PCCard bus> on cbb0 >>fwohci0: <1394 Open Host Controller Interface> mem 0xfaff8000-0xfaffbfff,0xfaffd800-0xfaffdfff irq 11 at device 1.1 on pci2 >>fwohci0: OHCI version 1.10 (ROM=0) >>fwohci0: No. of Isochronous channels is 4. >>fwohci0: EUI64 5b:4f:c0:00:3f:ff:ff:ff >>fwohci0: Phy 1394a available S400, 2 ports. >>fwohci0: Link S400, max_rec 2048 bytes. >>firewire0: <IEEE1394(FireWire) bus> on fwohci0 >>sbp0: <SBP-2/SCSI over FireWire> on firewire0 >>fwe0: <Ethernet over FireWire> on firewire0 >>if_fwe0: Fake Ethernet address: 5a:4f:c0:ff:ff:ff >>fwe0: Ethernet address: 5a:4f:c0:ff:ff:ff >>fwe0: if_start running deferred for Giant >>fwohci0: Initiate bus reset >>fwohci0: node_id=0xc800ffc0, gen=1, CYCLEMASTER mode >>firewire0: 1 nodes, maxhop <= 0, cable IRM = 0 (me) >>firewire0: bus manager 0 (me) >>pci2: <network> at device 3.0 (no driver attached) >>isab0: <PCI-ISA bridge> at device 31.0 on pci0 >>isa0: <ISA bus> on isab0 >>atapci0: <Intel ICH4 UDMA100 controller> port 0xbfa0-0xbfaf,0x376,0x170-0x177,0x3f6,0x1f0-0x1f7 at device 31.1 on pci0 >>ata0: channel #0 on atapci0 >>ata1: channel #1 on atapci0 >>pcm0: <Intel ICH4 (82801DB)> port 0xbc40-0xbc7f,0xb800-0xb8ff mem 0xf4fff400-0xf4fff4ff,0xf4fff800-0xf4fff9ff irq 11 at device 31.5 on pci0 >>pcm0: [GIANT-LOCKED] >>pcm0: <SigmaTel STAC9750/51 AC97 Codec> >>pci0: <simple comms> at device 31.6 (no driver attached) >>cpu0 on motherboard >>orm0: <ISA Option ROMs> at iomem 0xcf800-0xcffff,0xc0000-0xcf7ff on isa0 >>pmtimer0 on isa0 >>atkbdc0: <Keyboard controller (i8042)> at port 0x64,0x60 on isa0 >>atkbd0: <AT Keyboard> irq 1 on atkbdc0 >>kbd0 at atkbd0 >>atkbd0: [GIANT-LOCKED] >>psm0: <PS/2 Mouse> irq 12 on atkbdc0 >>psm0: [GIANT-LOCKED] >>psm0: model GlidePoint, device ID 0 >>ppc0: <Parallel port> at port 0x378-0x37f irq 7 on isa0 >>ppc0: SMC-like chipset (ECP/EPP/PS2/NIBBLE) in COMPATIBLE mode >>ppc0: FIFO with 16/16/8 bytes threshold >>ppbus0: <Parallel port bus> on ppc0 >>plip0: <PLIP network interface> on ppbus0 >>lpt0: <Printer> on ppbus0 >>lpt0: Interrupt-driven port >>ppi0: <Parallel I/O> on ppbus0 >>sc0: <System console> at flags 0x100 on isa0 >>sc0: VGA <16 virtual consoles, flags=0x300> >>sio0 at port 0x3f8-0x3ff irq 4 flags 0x10 on isa0 >>sio0: type 16550A >>sio1: configured irq 3 not in bitmap of probed irqs 0 >>sio1: port may not be enabled >>vga0: <Generic ISA VGA> at port 0x3c0-0x3df iomem 0xa0000-0xbffff on isa0 >>unknown: <PNP0303> can't assign resources (port) >>unknown: <PNP0f13> can't assign resources (irq) >>unknown: <PNP0501> can't assign resources (port) >>unknown: <PNP0401> can't assign resources (port) >>Timecounter "TSC" frequency 1698565329 Hz quality 800 >>Timecounters tick every 10.000 msec >>IP Filter: v3.4.35 initialized. Default = pass all, Logging = enabled >>cardbus0: <network, ethernet> at device 0.0 (no driver attached) >>cbb0: CardBus card activation failed >>ad0: 57231MB <HTS726060M9AT00/MH4OA68A> [116280/16/63] at ata0-master PIO4 >>ATAPI_RESET time = 30us >>acd0: CDRW <_NEC DVD+RW ND-5100A/10AC> at ata1-master PIO4 >>Mounting root from ufs:/dev/ad0s3a >>cardbus0: Expecting link target, got 0xff >>cardbus0: <old> at device 0.0 (no driver attached) >>cbb0: CardBus card activation failed >> >> >> >>_______________________________________________ >>freebsd-current_at_freebsd.org mailing list >>http://lists.freebsd.org/mailman/listinfo/freebsd-current >>To unsubscribe, send any mail to "freebsd-current-unsubscribe_at_freebsd.org" >> >> >> >> >> > > > >Received on Fri Oct 01 2004 - 01:33:48 UTC
This archive was generated by hypermail 2.4.0 : Wed May 19 2021 - 11:38:15 UTC