I installed 5.3-BETA2 from my university's mirror the other night and had no problem using the ftp to transfer large files to install my system. However, when attempting to cvsup the system today it abruptly stopped in the middle and acted as if there was no longer a connection available. I get rl0: discard oversize frame (ether type 800 flags 3 len 63907 > max 1514) after a long time of waiting (I went to class and when I came back I saw that in demsg). With a little research, I know this is a problem other's have had, but I have yet to see a post to freebsd-current about it. If there is any other information that is needed, I will do my best to provide it; I'm limited time-wise due to strenuous course-load, but I promise I'll dedicate some time to it ;) uname -a: FreeBSD .dynamic.rpi.edu 5.3-BETA2 FreeBSD 5.3-BETA2 #1: Sat Aug 28 21:29:15 UTC 2004 root_at_mack.dcsl.buffalo.edu:/usr/obj/usr/src/sys/GENERIC i386 dmesg: Copyright (c) 1992-2004 The FreeBSD Project. Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994 The Regents of the University of California. All rights reserved. FreeBSD 5.3-BETA2 #1: Sat Aug 28 21:29:15 UTC 2004 root_at_mack.dcsl.buffalo.edu:/usr/obj/usr/src/sys/GENERIC WARNING: WITNESS option enabled, expect reduced performance. Timecounter "i8254" frequency 1193182 Hz quality 0 CPU: Intel Pentium III (498.27-MHz 686-class CPU) Origin = "GenuineIntel" Id = 0x681 Stepping = 1 Features=0x383f9ff<FPU,VME,DE,PSE,TSC,MSR,PAE,MCE,CX8,SEP,MTRR,PGE,MCA,CMOV,PAT,PSE36,MMX,FXSR,SSE> real memory = 268238848 (255 MB) avail memory = 252846080 (241 MB) npx0: [FAST] npx0: <math processor> on motherboard npx0: INT 16 interface pcib0: <Intel 82443BX (440 BX) host to PCI bridge> pcibus 0 on motherboard pir0: <PCI Interrupt Routing Table: 6 Entries> on motherboard pci0: <PCI bus> on pcib0 agp0: <Intel 82443BX (440 BX) host to PCI bridge> mem 0x40000000-0x43ffffff at device 0.0 on pci0 pcib1: <PCIBIOS PCI-PCI bridge> at device 1.0 on pci0 pci1: <PCI bus> on pcib1 pci1: <display, VGA> at device 0.0 (no driver attached) cbb0: <TI1450 PCI-CardBus Bridge> mem 0x50103000-0x50103fff irq 11 at device 2.0 on pci0 cardbus0: <CardBus bus> on cbb0 pccard0: <16-bit PCCard bus> on cbb0 cbb1: <TI1450 PCI-CardBus Bridge> mem 0x50102000-0x50102fff irq 11 at device 2.1 on pci0 cardbus1: <CardBus bus> on cbb1 pccard1: <16-bit PCCard bus> on cbb1 pci0: <simple comms> at device 3.0 (no driver attached) pci0: <multimedia, audio> at device 6.0 (no driver attached) isab0: <PCI-ISA bridge> at device 7.0 on pci0 isa0: <ISA bus> on isab0 atapci0: <Intel PIIX4 UDMA33 controller> port 0xfcf0-0xfcff,0x376,0x170-0x177,0x3f6,0x1f0-0x1f7 at device 7.1 on pci0 ata0: channel #0 on atapci0 ata1: channel #1 on atapci0 uhci0: <Intel 82371AB/EB (PIIX4) USB controller> port 0x4000-0x401f irq 11 at device 7.2 on pci0 uhci0: [GIANT-LOCKED] usb0: <Intel 82371AB/EB (PIIX4) USB controller> on uhci0 usb0: USB revision 1.0 uhub0: Intel UHCI root hub, class 9/0, rev 1.00/1.00, addr 1 uhub0: 2 ports with 2 removable, self powered piix0: <PIIX Timecounter> port 0xefa0-0xefaf at device 7.3 on pci0 Timecounter "PIIX" frequency 3579545 Hz quality 0 cpu0 on motherboard orm0: <ISA Option ROM> at iomem 0xc0000-0xcbfff on isa0 pmtimer0 on isa0 atkbdc0: <Keyboard controller (i8042)> at port 0x64,0x60 on isa0 atkbd0: <AT Keyboard> irq 1 on atkbdc0 kbd0 at atkbd0 atkbd0: [GIANT-LOCKED] psm0: <PS/2 Mouse> irq 12 on atkbdc0 psm0: [GIANT-LOCKED] psm0: model Generic PS/2 mouse, device ID 0 fdc0: <Enhanced floppy controller (i82077, NE72065 or clone)> at port 0x3f7,0x3f0-0x3f5 irq 6 drq 2 on isa0 ppc0: parallel port not found. sc0: <System console> at flags 0x100 on isa0 sc0: VGA <16 virtual consoles, flags=0x300> sio0: configured irq 4 not in bitmap of probed irqs 0 sio0: port may not be enabled sio0 at port 0x3f8-0x3ff irq 4 flags 0x10 on isa0 sio0: type 8250 or not responding sio1: configured irq 3 not in bitmap of probed irqs 0 sio1: port may not be enabled vga0: <Generic ISA VGA> at port 0x3c0-0x3df iomem 0xa0000-0xbffff on isa0 unknown: <PNP0303> can't assign resources (port) unknown: <IBM3780> can't assign resources (irq) unknown: <PNP0700> can't assign resources (port) unknown: <PNP0c02> can't assign resources (port) ppc1: parallel port not found. ahc0: No resources alloated. ahc0: No resources alloated. ahc0: No resources alloated. unknown: <PNP0e03> can't assign resources (port) unknown: <PNP0680> can't assign resources (port) unknown: <PNP0680> can't assign resources (port) ahc0: No resources alloated. Timecounter "TSC" frequency 498274133 Hz quality 800 Timecounters tick every 10.000 msec cardbus1: Expecting link target, got 0xff cardbus1: Resource not specified in CIS: id=10, size=100 cardbus1: Resource not specified in CIS: id=14, size=200 rl0: <D-Link DFE-690TXD 10/100BaseTX> port 0x1000-0x10ff mem 0x88000000-0x880001ff irq 11 at device 0.0 on cardbus1 miibus0: <MII bus> on rl0 rlphy0: <RealTek internal media interface> on miibus0 rlphy0: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto rl0: Ethernet address: 00:40:05:0b:7c:cd rl0: [GIANT-LOCKED] ad0: 11509MB <IBM-DARA-212000/AR4IA52A> [24944/15/63] at ata0-master UDMA33 ATAPI_RESET time = 100us acd0: DVDROM <TOSHIBA DVD-ROM SD-C2302/1617> at ata1-master PIO4 Mounting root from ufs:/dev/ad0s1a Accounting enabled rl0: discard oversize frame (ether type 800 flags 3 len 63907 > max 1514) -- David WeinsteinReceived on Tue Sep 07 2004 - 19:35:44 UTC
This archive was generated by hypermail 2.4.0 : Wed May 19 2021 - 11:38:10 UTC