On 27/07/2005, at 22:15, Tim Bishop wrote: > On Tue, Jul 26, 2005 at 01:30:26PM +0200, Frode Nordahl wrote: > >>> Hello, >>> >>> I am having trouble rebuilding my ATA / SATA RAIDs with 6.0-BETA1. >>> >>> # atacontrol status ar0 >>> ar0: ATA RAID1 subdisks: DOWN ad6 status: DEGRADED >>> >>> # atacontrol addspare ar0 ad4 >>> ad4: inserted into ar0 disk0 as spare >>> >>> # atacontrol rebuild ar0 >>> >>> # atacontrol status ar0 >>> ar0: ATA RAID1 subdisks: ad4 ad6 status: REBUILDING 0% completed >>> >>> And then it just sits at 0% forever. I started a rebuild process on >>> the Promise this friday, and it is still at 0%. >>> >> >> *) The dd starts and finishes, but status stays at 0%, and the RAID >> is never marked as clean >> > > I'm seeing the same thing here with 6.0-BETA1. Have you got any > further > with this? Are you sure that atacontrol is in sync with the kernel ? the ioctl interface changed some time ago. At any rate UNLESS your disks are on a "write metadata" supported controller, the rebuild wont survive a boot since the metadata cannot be written back to the disks. The kernel will complain to this fact if it applies to your system. - SørenReceived on Thu Jul 28 2005 - 17:17:52 UTC
This archive was generated by hypermail 2.4.0 : Wed May 19 2021 - 11:38:40 UTC