On 28. jul. 2005, at 21.17, Søren Schmidt wrote: > Are you sure that atacontrol is in sync with the kernel ? the ioctl > interface changed some time ago. Yes, I run with a fresh install from 6.0-BETA1 ISO. > At any rate UNLESS your disks are on a "write metadata" supported > controller, the rebuild wont survive a boot since the metadata > cannot be written back to the disks. The kernel will complain to > this fact if it applies to your system. I did the previous tests on a onboard Promise FastTrak 150 ATA controller, and on a ICH5 in SATA mode, using FreeBSD Pseudoraid. Now testing on a genuine Promise PCI SATA controller: # dmesg |grep ^atapci0 atapci0: <Promise PDC20571 SATA150 controller> port 0x7400-0x747f, 0x7000-0x70ff mem 0xf0220000-0xf0220fff,0xf0200000-0xf021ffff irq 24 at device 1.0 on pci3 # dmesg |grep ^ar0 ar0: 77247MB <Promise Fasttrak RAID1> status: READY ar0: disk0 READY (master) using ad4 at ata2-master ar0: disk1 READY (mirror) using ad6 at ata3-master On this machine the dd runs as it should, but atacontrol status shows 0% all the way through, and the RAID is still broken. Frode Nordahl frode_at_nordahl.netReceived on Thu Jul 28 2005 - 19:36:16 UTC
This archive was generated by hypermail 2.4.0 : Wed May 19 2021 - 11:38:40 UTC