Re: wpa_supplicant + NDIS (broadcom) + linksys WRT54G possible?

Doug Barton wrote:
> Sam Leffler wrote:

>> You would probably better off setting up an ap where you can see 
>> what's happening on the ap side.  Since you have an ath card you could 
>> use that to test with (even in the same laptop).
> 
> 
> I can try that, be a couple days before I get to it though. 

Ok, I finally got around to this. Using the wpa code that Sam just committed 
to -current, I set up the ath card in hostap mode, and ran wpa_supplicant on 
the ndis card.

Here is the ath (hostap) side:
ath0: STA 00:90:4b:63:5f:e0 IEEE 802.11: associated
   New STA
ath0: STA 00:90:4b:63:5f:e0 WPA: event 1 notification
ath0: STA 00:90:4b:63:5f:e0 WPA: start authentication
WPA: 00:90:4b:63:5f:e0 WPA_PTK entering state INITIALIZE
bsd_del_key: addr=00:90:4b:63:5f:e0 key_idx=0
ath0: STA 00:90:4b:63:5f:e0 IEEE 802.1X: unauthorizing port
bsd_set_sta_authorized: addr=00:90:4b:63:5f:e0 authorized=0
WPA: 00:90:4b:63:5f:e0 WPA_PTK_GROUP entering state IDLE
WPA: 00:90:4b:63:5f:e0 WPA_PTK entering state AUTHENTICATION
WPA: 00:90:4b:63:5f:e0 WPA_PTK entering state AUTHENTICATION2
WPA: 00:90:4b:63:5f:e0 WPA_PTK entering state INITPSK
WPA: 00:90:4b:63:5f:e0 WPA_PTK entering state PTKSTART
ath0: STA 00:90:4b:63:5f:e0 WPA: sending 1/4 msg of 4-Way Handshake
TX EAPOL - hexdump(len=113): 00 90 4b 63 5f e0 00 0d 88 8a 77 c6 88 8e 01 03 
00 5f fe 00 89 00 20 00 00 00 00 00 00 00 01 27 55 b1 da 18 ef 6e 41 78 4b 
6c b3 31 26 56 9a a9 28 9a 9f d7 73 fe 01 d0 38 dc ba 59 93 5e 9b 00 00 00 
00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 
00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
IEEE 802.1X: 123 bytes from 00:90:4b:63:5f:e0
    IEEE 802.1X: version=1 type=3 length=119
ath0: STA 00:90:4b:63:5f:e0 WPA: WPA IE from (Re)AssocReq did not match with 
msg 2/4
WPA IE in AssocReq - hexdump(len=26): dd 18 00 50 f2 01 01 00 00 50 f2 02 01 
00 00 50 f2 02 01 00 00 50 f2 02 00 00
WPA IE in msg 2/4 - hexdump(len=24): dd 16 00 50 f2 01 01 00 00 50 f2 02 01 
00 00 50 f2 02 01 00 00 50 f2 02
bsd_sta_deauth: addr=00:90:4b:63:5f:e0 reason_code=2
ath0: STA 00:90:4b:63:5f:e0 IEEE 802.11: deauthenticated due to local deauth 
request
ath0: STA 00:90:4b:63:5f:e0 IEEE 802.11: deassociated
ath0: STA 00:90:4b:63:5f:e0 IEEE 802.11: associated
   New STA
ath0: STA 00:90:4b:63:5f:e0 WPA: event 1 notification
ath0: STA 00:90:4b:63:5f:e0 WPA: start authentication
WPA: 00:90:4b:63:5f:e0 WPA_PTK entering state INITIALIZE
bsd_del_key: addr=00:90:4b:63:5f:e0 key_idx=0
ath0: STA 00:90:4b:63:5f:e0 IEEE 802.1X: unauthorizing port
bsd_set_sta_authorized: addr=00:90:4b:63:5f:e0 authorized=0
WPA: 00:90:4b:63:5f:e0 WPA_PTK_GROUP entering state IDLE
WPA: 00:90:4b:63:5f:e0 WPA_PTK entering state AUTHENTICATION
WPA: 00:90:4b:63:5f:e0 WPA_PTK entering state AUTHENTICATION2
WPA: 00:90:4b:63:5f:e0 WPA_PTK entering state INITPSK
WPA: 00:90:4b:63:5f:e0 WPA_PTK entering state PTKSTART
ath0: STA 00:90:4b:63:5f:e0 WPA: sending 1/4 msg of 4-Way Handshake
TX EAPOL - hexdump(len=113): 00 90 4b 63 5f e0 00 0d 88 8a 77 c6 88 8e 01 03 
00 5f fe 00 89 00 20 00 00 00 00 00 00 00 01 27 55 b1 da 18 ef 6e 41 78 4b 
6c b3 31 26 56 9a a9 28 9a 9f d7 73 fe 01 d0 38 dc ba 59 93 5e 9c 00 00 00 
00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 
00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
IEEE 802.1X: 123 bytes from 00:90:4b:63:5f:e0
    IEEE 802.1X: version=1 type=3 length=119
ath0: STA 00:90:4b:63:5f:e0 WPA: WPA IE from (Re)AssocReq did not match with 
msg 2/4
WPA IE in AssocReq - hexdump(len=26): dd 18 00 50 f2 01 01 00 00 50 f2 02 01 
00 00 50 f2 02 01 00 00 50 f2 02 00 00
WPA IE in msg 2/4 - hexdump(len=24): dd 16 00 50 f2 01 01 00 00 50 f2 02 01 
00 00 50 f2 02 01 00 00 50 f2 02
bsd_sta_deauth: addr=00:90:4b:63:5f:e0 reason_code=2
ath0: STA 00:90:4b:63:5f:e0 IEEE 802.11: deauthenticated due to local deauth 
request
ath0: STA 00:90:4b:63:5f:e0 IEEE 802.11: deassociated


And here is the ndis side:
Trying to associate with 00:0d:88:8a:77:c6 (SSID='wpa-test' freq=2412 MHz)
Cancelling scan request
Automatic auth_alg selection: 0x1
WPA: using IEEE 802.11i/D3.0
WPA: Selected cipher suites: group 8 pairwise 8 key_mgmt 2
WPA: using GTK TKIP
WPA: using PTK TKIP
WPA: using KEY_MGMT WPA-PSK
WPA: Own WPA IE - hexdump(len=24): dd 16 00 50 f2 01 01 00 00 50 f2 02 01 00 
00 50 f2 02 01 00 00 50 f2 02
No keys have been configured - skip key clearing
wpa_driver_bsd_set_drop_unencrypted: enabled=1
wpa_driver_bsd_associate
Setting authentication timeout: 5 sec 0 usec
RX EAPOL from 00:0d:88:8a:77:c6
Setting authentication timeout: 10 sec 0 usec
IEEE 802.1X RX: version=1 type=3 length=95
   EAPOL-Key type=254
WPA: RX message 1 of 4-Way Handshake from 00:0d:88:8a:77:c6 (ver=1)
WPA: WPA IE for msg 2/4 - hexdump(len=24): dd 16 00 50 f2 01 01 00 00 50 f2 
02 01 00 00 50 f2 02 01 00 00 50 f2 02
WPA: Renewed SNonce - hexdump(len=32): 71 cc f2 16 d3 bf fe 59 72 ee 19 61 
ea e6 11 fb 07 ef 9f a3 01 83 67 c4 78 54 6a c2 4d 2e 29 12
WPA: PMK - hexdump(len=32): [REMOVED]
WPA: PTK - hexdump(len=64): [REMOVED]
WPA: EAPOL-Key MIC - hexdump(len=16): 5a 6b 0e 62 1d 10 d5 b4 89 c2 0b a6 72 
70 e9 66
WPA: Sending EAPOL-Key 2/4
RX EAPOL from 00:0d:88:8a:77:c6
IEEE 802.1X RX: version=1 type=3 length=95
   EAPOL-Key type=254
WPA: RX message 1 of 4-Way Handshake from 00:0d:88:8a:77:c6 (ver=1)
WPA: WPA IE for msg 2/4 - hexdump(len=24): dd 16 00 50 f2 01 01 00 00 50 f2 
02 01 00 00 50 f2 02 01 00 00 50 f2 02
WPA: PMK - hexdump(len=32): [REMOVED]
WPA: PTK - hexdump(len=64): [REMOVED]
WPA: EAPOL-Key MIC - hexdump(len=16): 24 e2 bc 1e a1 5d ad 71 29 e9 fa b2 5f 
e4 2d a9
WPA: Sending EAPOL-Key 2/4

Hope this helps,

Doug


-- 

     This .signature sanitized for your protection