Re: Using nvidia-driver with 6-x/CURRENT

If you use burncd instead of cdrecord there is no need for atapicam in the 
kernel or as a module.  It appears you are only using for your CD drives.
For simple burning, burncd is enough.
On Monday 09 May 2005 12:48, Rudolf Cejka wrote:
> David Gurvich wrote (2005/05/08):
> > I was able to install v.7174 from the port after modifying nv-freebsd.h.
> > This consisted of commenting out the portion where an error is given if
> > the freebsd version is greater than 6.
>
> Hello, thanks for the information. I tried today's current with the new
> nvidia driver and here are my first rough experiences:
>
> - I adjusted Makefile and distinfo from 6113 to 7174, then removed all
>   patches for 6113 in directory files and put here just one patch for
>   nv-freebsd.h, which removes above mentioned error. There seems to be
>   needed more adjustments for the port, but wow - I'm able after very
>   long time with my NVidia FX5200 to switch between graphics and text mode
>   again - great.
>
> - However when updating to the todays -current, I had to disable atapicam
>   from my kernel, because it stopped my system from booting. It hanged
>   after acd1  message - here are the last booting lines:
>   ...
>   sym0: <875> port 0xd000-0xd0ff mem
> 0xfbefec00-0xfbefecff,0xfbefd000-0xfbefdfff irq 5 at device 9.0 on pci2
> sym0: Symbios NVRAM, ID 7, Fast-20, SE, parity checking
>   sym0: open drain IRQ line driver, using on-chip SRAM
>   sym0: using LOAD/STORE-based firmware.
>   sym0: [GIANT-LOCKED]
>   ...
>   Timecounters tick every 1.000 msec
>   IPsec: Initialized Security Association Processing.
>   ad0: 76319MB <WDC WD800JB-00ETA0 77.07W77> at ata0-master UDMA100
>   acd0: CDRW <HL-DT-ST GCE-8520B/1.04> at ata1-master UDMA33
>   acd1: CDROM <CDU5211/YYS7> at ata1-slave UDMA33
>
>   When I removed SCSI controller from my computer, I was able to boot
>   the kernel again, but it paniced shortly. However removing atapicam
>   from kernel configuration seems to be sufficient. In kernel without
>   atapicam, kldload atapicam seems that it does nothing, kldunload atapicam
>   panics the system with current process = 33 (swi2: cambio).