Marvell ATA controller on intel desktop boards.

From: Martin Nilsson <martin_at_gneto.com>
Date: Tue, 28 Nov 2006 05:05:16 +0100
Hi Søren,

I've got a couple of intel boards for my home machines they are DP965LT 
and DG965SS, I've noticed that the ATA controllers are recognised but 
not my DVD drives that are connected to them!
This is: 6.2-PRERELEASE FreeBSD 6.2-PRERELEASE #0: Fri Nov 24.
Is there anything you can do without having access to the hardware?

atapci0: <GENERIC ATA controller> port 
0x2018-0x201f,0x2024-0x2027,0x2010-0x2017,0x2020-0x2023,0x2000-0x2
00f mem 0x32100000-0x321001ff irq 17 at device 0.0 on pci3
ata2: <ATA channel 0> on atapci0
ata3: <ATA channel 1> on atapci0

lspci -v gives:
03:00.0 IDE interface: Marvell Technology Group Ltd. Unknown device 6101 
(rev b1) (prog-if 8f [Master SecP SecO PriP PriO])
         Subsystem: Marvell Technology Group Ltd. Unknown device 6101
         Flags: bus master, fast devsel, latency 0, IRQ 17
         I/O ports at 2018
         I/O ports at 2024
         I/O ports at 2010
         I/O ports at 2020
         I/O ports at 2000
         Memory at 32100000 (32-bit, non-prefetchable)
         Capabilities: [48] Power Management version 2
         Capabilities: [50] Message Signalled Interrupts: 64bit- 
Queue=0/0 Enable-
         Capabilities: [e0] Express Legacy Endpoint IRQ 0


Regards,
Martin
Received on Tue Nov 28 2006 - 04:35:13 UTC

This archive was generated by hypermail 2.4.0 : Wed May 19 2021 - 11:39:03 UTC