At 06:44 PM 10/11/2006, adam radford wrote: >'vkashyap' is no longer maintaining the 3ware 'twa' driver. > >'twa' driver in RELENG_6 and CURRENT both support 9550SXU and >9590SE controllers at this time. They both have the 0x1003 device ID. > >I will be sending an update in the near future to support the new series of >9650SE controllers, remove bundled firmware (we have a FreeBSD specific >userspace firmware update utility), and remove lots of non FreeBSD specific >code. Hi, We are just in the process of evaluating the new 9650se cards, and RELENG_6 does not actually recognize them. none1_at_pci2:0:0: class=0x010400 card=0x100413c1 chip=0x100413c1 rev=0x01 hdr=0x00 vendor = '3ware Inc.' class = mass storage subclass = RAID cap 01[40] = powerspec 2 supports D0 D1 D2 D3 current D0 cap 05[50] = MSI supports 32 messages, 64 bit cap 10[70] = PCI-Express 1 legacy endpoint Are there still plans to integrate support for the newer generation of cards into the FreeBSD src tree ? Using the driver off the website, it seems to work OK but doing installs this way is bit of a pain twa0: <3ware 9000 series Storage Controller> port 0x3000-0x30ff mem 0x88000000-0x89ffffff,0x8a200000-0x8a200fff irq 16 at device 0.0 on pci2 twa0: [FAST] twa0: INFO: (0x15: 0x1300): Controller details:: Model 9650SE-2LP, 2 ports, Firmware FE9X 3.06.00.005, BIOS BE9X 3.06.00.002 da0 at twa0 bus 0 target 0 lun 0 da0: <AMCC 9650SE-2LP DISK 3.06> Fixed Direct Access SCSI-5 device da0: 100.000MB/s transfers da0: 76283MB (156227584 512 byte sectors: 255H 63S/T 9724C) ---Mike >-Adam > >On 10/11/06, freebsd_at_bitfreak.org <freebsd_at_bitfreak.org> wrote: >>I just noticed that, based on the commit logs, the twa(4) driver is >>still the driver from the 9.3.0.1 release from 3ware. That version >>doesn't support the new 9550SXU and 9590SE controllers, the later being >>3ware's new PCI Express card. Is anyone currently planning/testing an >>update to the 9.3.0.7 release? I tried emailing the only address listed >>(vkashyap) in the logs and source, but it bounced. So I'm not sure who >>contact. Should this wait until after the 6.2 release? >>_______________________________________________ >>freebsd-current_at_freebsd.org mailing list >>http://lists.freebsd.org/mailman/listinfo/freebsd-current >>To unsubscribe, send any mail to "freebsd-current-unsubscribe_at_freebsd.org" >_______________________________________________ >freebsd-current_at_freebsd.org mailing list >http://lists.freebsd.org/mailman/listinfo/freebsd-current >To unsubscribe, send any mail to "freebsd-current-unsubscribe_at_freebsd.org"Received on Wed Apr 11 2007 - 20:03:10 UTC
This archive was generated by hypermail 2.4.0 : Wed May 19 2021 - 11:39:08 UTC