Aryeh M. Friedman wrote: > Jeremy Chadwick wrote: > >> On Tue, Nov 06, 2007 at 03:31:35AM -0500, Aryeh M. Friedman wrote: >> >> >>> Xin LI wrote: >>> >>> >>>> Yes (so that you get the correct speed of ICH9, ironically I have >>>> misunderstood the spec). I am working on a new patch. >>>> >>>> >>> The speeds are still incorrect (150 instead of 300) >>> >>> >> According to the thread and Wiki data I see, you're complaining that the >> following two devices on your SATA bus are SATA150 when they should be >> SATA300, correct? >> >> Master: ad8 <ST3500630AS/3.AAE> Serial ATA v1.0 >> Master: acd0 <TSSTcorpCD/DVDW SH-S183L/SB01> Serial ATA v1.0 >> >> > > yes btw due to god knows what reason the patch renumbered ad8 to ad6 > Depends on whether or not AHCI vs IDE (aka 'compatibility-mode') is involved, and whether or not you have multiple SATA controllers in the mix (for instance ASUS MBs have one ICHx + JBMicron controller, each). >> 1) Have you verified that the SATA150-limiting jumper on your Seagate >> drive has been removed? SATA300 drives from Seagate come from the >> factory with that jumper connected, limiting the drive to SATA150. >> >> > > I will check but: > > 1. I was unaware of this "feature" > 2. I didn't see any jumpers when I installed it > >> 2) Do you happen to be using a PATA-to-SATA adapter on the DVD drive? >> >> > > It is native SATA (300) > >> 3) If No to #2, are you sure that the ICH9 does SATA300 with ATAPI >> devices? Does the mainboard BIOS even support it for ATAPI? >> >> > > Mobo has ATAPI I am not sure about the IHC issue though... will look it > > > > up and get back to you. Make sure you don't have cheap / SATA300 incompatible cables :). FWIW, my ICH9 enabled P5K-E Wifi MB has zero problems with FreeBSD 7-CURRENT/8-CURRENT. What flavor of MB do you have? -GarrettReceived on Tue Nov 06 2007 - 08:58:08 UTC
This archive was generated by hypermail 2.4.0 : Wed May 19 2021 - 11:39:21 UTC