At 06:34 PM 11/26/2007, Barney Cordoba wrote: >(http://lists.freebsd.org/pipermail/freebsd-current/2007-November/079920.html) > > There obviously are some cases were it does not, so > > its harder to > > track down than just a case of spending $150. If > > you do have such a > > board that does not work, perhaps make the offer of > > sending the > > problem board to a developer who is interested in > > fixing the issue. > > > > ---Mike > > >Hello Mike, > >It "works" in 6.x, albeit not in SATA mode, which kind >of detracts from using a really, really fast SATA >chipset. FreeBSD 7 doesn't work at all on the chipset >in any mode that can be set in the bios. You just get >signal 11s all over the place, bad file reads, etc. Hi, I thought thats what I was using ? # atacontrol info ata2 Master: ad4 <ST380811AS/3.AAE> Serial ATA II Slave: no device present # atacontrol cap ad4 Protocol Serial ATA II device model ST380811AS serial number 6PS0C1LW firmware revision 3.AAE cylinders 16383 heads 16 sectors/track 63 lba supported 156301488 sectors lba48 supported 156301488 sectors dma supported overlap not supported Feature Support Enable Value Vendor write cache yes yes read ahead yes yes Native Command Queuing (NCQ) yes - 31/0x1F Tagged Command Queuing (TCQ) no no 31/0x1F SMART yes yes microcode download yes yes security yes no power management yes yes advanced power management no no 65278/0xFEFE automatic acoustic management no no 0/0x00 208/0xD0 # grep HT /var/run/dmesg.boot atapci0: <ServerWorks HT1000 SATA150 controller> port 0xc080-0xc087,0xc000-0xc003,0xbc00-0xbc07,0xb880-0xb883,0xb800-0xb81f mem 0xff3fe000-0xff3fffff irq 11 at device 14.0 on pci1 atapci1: <ServerWorks HT1000 UDMA100 controller> port 0x1f0-0x1f7,0x3f6,0x170-0x177,0x376,0xffa0-0xffaf at device 2.1 on pci0 6.3-PRERELEASE FreeBSD 6.3-PRERELEASE #1: Thu Oct 25 21:54:13 EDT 2007Received on Mon Nov 26 2007 - 23:14:21 UTC
This archive was generated by hypermail 2.4.0 : Wed May 19 2021 - 11:39:23 UTC