Re: New if_zyd driver

[Quoting Weongyo Jeong, on Oct 20, 13:43, in "Re: New if_zyd drive ..."]
....
> I send you a patch which is attached with this email to fix a reset
> problem of the zyd driver when we reboot.
> 
> In my environment, this patch was worked.  Would you please test this
> patch and send me results?  I hope it works.  :-)

Sorry for the delay (I am traveling by boat with very limited
internet access).

I have applied the patch and rebooted with the new kernel.
However, the zyd-card does not work after the warm boot.
Yanking and reinstalling the stick fixes the problem, though.

The relevant logs.
After the warm reboot:
 zyd0: <ZyDAS USB2.0 WLAN, class 255/255, rev 2.00/48.10, addr 2> on uhub4
 zyd0: could not load firmware (error=5)
 device_attach: zyd0 attach returned 5
 pcib1: <ACPI PCI-PCI bridge> at device 30.0 on pci0
 pcib1:   domain            0

after yanking and reinserting:
 zyd0: at uhub4 port 1 (addr 2) disconnected
 zyd0: <ZyDAS USB2.0 WLAN, class 255/255, rev 2.00/48.10, addr 2> on uhub4
 zyd0: HMAC ZD1211B, FW 47.25, RF AL2230, PA 0, address 00:02:72:57:48:76
 zyd0: bpf attached
 zyd0: Ethernet address: 00:02:72:57:48:76
 zyd0: if_start running deferred for Giant
 zyd0: bpf attached
 zyd0: bpf attached
 zyd0: 11b rates: 1Mbps 2Mbps 5.5Mbps 11Mbps
 zyd0: 11g rates: 1Mbps 2Mbps 5.5Mbps 11Mbps 6Mbps 9Mbps 12Mbps 18Mbps 24Mbps 36M
 bps 48Mbps 54Mbps
 zyd0: link state changed to UP

Regards,
-- ted