RE: Only 100baseTX with bge BCM5722

On Tue, 1 Apr 2008 10:18:55 -0700, David Christensen wrote
> > Hello!
> >
> > Scenario:
> >
> > * Machine: HP Proliant ML110 G5
> > * Integrated NIC: Broadcom NetXtreme BCM5722 Gigabit Ethernet PCIe
> > * FreeBSD 7.0
> > * Kernel recompiled patching bge driver as explained at
> > http://www.freebsd.org/cgi/query-pr.cgi?pr=kern/119779
> >
> > The card works only at 100baseTX:
> >
> > media: Ethernet autoselect (100baseTX <full-duplex>)
> > status: active
> >
> > If I try:
> >
> > # ifconfig bge0 media 1000baseTX mediaopt full-duplex
> >
> > I obtain:
> >
> > media: Ethernet 1000baseTX <full-duplex>
> > status: no carrier
> >
> > Of course, the card is connected to a Gigabit switch, as other FreeBSD
> > machines that we have.
> >
> > The problem seems similar to
> > http://lists.freebsd.org/pipermail/freebsd-
> > current/2008-April/084606.html
> >
> > Any idea?
> 
> What's the dmesg output?  Is it using ukphy or brgphy?
> 
> Dave
> 
> _______________________________________________

Dave,

Partial dmesg, concerning the NIC:

pcib4: <ACPI PCI-PCI bridge> irq 17 at device 28.5 on pci0
pci14: <ACPI PCI bus> on pcib4
bge0: <HP NC105i PCIe Gigabit Server Adapter, ASIC rev. 0xa200> mem 
0xed000000-0xed00ffff irq 17 at device 0.0 on pci14
miibus0: <MII bus> on bge0
ukphy0: <Generic IEEE 802.3u media interface> PHY 1 on miibus0
ukphy0:  10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, 1000baseT, 
1000baseT-FDX, auto
bge0: Ethernet address: XXXXXXXXXXXXXXXXXXXXX
bge0: [ITHREAD]

bge0: link state changed to UP

Must I try 1000baseT-FDX instead than 1000baseTX in my ifconfig line?

Regards,

Josep Pujadas