On Fri, Apr 04, 2008 at 09:06:23AM -0400, Tuc at T-B-O-H.NET wrote: > > > > On Fri, Apr 04, 2008 at 12:24:26AM -0400, Tuc at T-B-O-H.NET wrote: > > > Hi, > > > > > > LONG LONG LONG story made short. > > > > > > Running Soekris 4801-60 previously on 5.5 . Would lock up > > > every so often, then more often, then finally constantly. Shipped > > > back to vendor, replaced, all good. Months later started to lock > > > every few weeks, then every few hours. Replace CF with hard drive, > > > locks in 10 minutes, etc. > > > > > > Load OpenBSD on disk. Runs for days with no problem. > > > Decide I don't like OpenBSD ports system so decide to go FreeBSD > > > 7. Glitch with memory stick, but otherwise system seems to run > > > fine. Start SETI, system locks HARD. I have it set to be able > > > to break to debugger with CR ~ ^b, but that just doesn't happen. > > > (Previously tested it would in single user when system running > > > fine). > > > > > > Is there any way to debug a kernel lockup if you CAN'T > > > break to debugger?? > > > > http://www.freebsd.org/doc/en_US.ISO8859-1/books/developers-handbook/kerneldebug.html > > > > Hope this helps. > > > Unfortunately, not that I can see. > > Kernel already had : > > options KDB > options KDB_TRACE > options KDB_UNATTENDED > options DDB > #break on sequence CR ~ ^b > options ALT_BREAK_TO_DEBUGGER > > And I couldn't break to the debugger for love nor money > once it happens. I also can't remote debug due to my 7.0 system not > having a serial port. > > Thanks, Tuc Do you have a firewire port? See http://www.lemis.com/grog/Papers/Debug-tutorial/tutorial.pdf for an explanation on how to setup firewire debugging. Regards, -- Rui PauloReceived on Fri Apr 04 2008 - 12:16:30 UTC
This archive was generated by hypermail 2.4.0 : Wed May 19 2021 - 11:39:29 UTC