Re: RFC: PCI SD host controller driver & mmc/mmcsd modules improvements

> In message: <be2f52430810180103v1a158866of96a3206e52b297d_at_mail.gmail.com>
>            "Jacques Fourie" <jacques.fourie_at_gmail.com> writes:
> : > Alexander Motin wrote:
> : >>
> : >> I would like to present initial revision of my generic PCI SD Host
> : >> Controller driver (sdhci). It support PCI devices with class 8 and subclass
> : >> 5 according to SD Host Controller Specification.
> : >> Latest patches against 8-CURRENT (mostly fit 7-STABLE) may be found at:
> : >> http://people.freebsd.org/~mav/sdhci/
> : >
> : > For those who are not tracking actively, I would like to report that most of
> : > original driver's child illnesses are now healed.
> : >
> : > Driver now supports both PIO and DMA modes. Because of some special tunings
> : > DMA works fine even on almost broken ENE chips. I am reaching 15MB/s
> : > transfer (maximum for my controller's bus) with only about 1% of CPU load.
> : > Implemented 4 bits bus width and high speed timing modes support for high
> : > data rates up to 52MHz. Cards hot insertion/removing is now working.
> : > Together with in-tree mmc/mmcsd drivers improvements most of card types (SD,
> : > SDHC, standard and high capacity MMC) are now supported.
> : >
> : > --
> : > Alexander Motin
> : > _______________________________________________
> : > freebsd-arm_at_freebsd.org mailing list
> : > http://lists.freebsd.org/mailman/listinfo/freebsd-arm
> : > To unsubscribe, send any mail to "freebsd-arm-unsubscribe_at_freebsd.org"
> : >
> :
> : The device in my HP nw8240 notebook is a Texas Instruments 7621. This
> : device is a multi-function PCI device with a CardBus, firewire, Flash
> : Media and SD controller. The only way that I could get this driver to
> : work for me is to disable SD card detection on the Flash Media
> : controller, which is function 3 :
> :
> : pcitweak -w 02:06:03 -b 0x4c 0x02
>
> I have patches to mav's sdhci driver to do this.  However, I can't get
> the driver to work.  It detects the cards are inserted, but then all
> commands that require a response from the card fail.
>
> How many slots does your controller report?  Which one is sd?
>
> Warner
>

My controller reports 3 slots, with the third one being sd.

Jacques