> On Aug 23, 2009, at 14:18, Thomas Backman wrote: > > > First off: Not subscribed to this list, please make sure to Cc me if > > you don't reply directly. :) > > > > Anyway, I finally got my null modem cable, and plugged in in between > > a machine running 8.0-BETA2 and one running WinXP using Hyperterminal. > > > > My settings: > > > > /boot/loader.conf: > > boot_multicons="YES" > > boot_serial="YES" > > comconsole_speed="115200" > > console="comconsole,vidconsole" > > > > /etc/ttys: > > # Serial terminals > > # The 'dialup' keyword identifies dialin lines to login, fingerd etc. > > ttyu0 "/usr/libexec/getty std.115200" vt100 on secure > > > > /boot.config (which is read properly): > > -Dh -S115200 > > > > Anything wrong in the above? > > Hyperterminal is set to 115200 bps, 8 bits, no parity, 1 stop bit, > > and no flow control (if that's the correct translation to English). > > > > On the serial console, I go from the screen with the FreeBSD logo, > > with single-user options etc. (which works fine), and then nothing, > > until a login tty pops up (which also works fine). The main, if not > > only, reason I want a serial console is to be able to use it for > > single user mode, DDB, and so on. > > All kernel messages, and all rc messages are seen only on the > > graphics card; the serial console receives nothing but the "/ > > boot.config: -Dh ...", the logo screen, and then the login screen, > > during startup and *nothing* at all during shutdown. Also, I'm able > > to login and use the system both via the serial console and via the > > graphics card/keyboard... Is this supposed to be? I'm not > > complaining, I just got the impression it was one or the other. > > > > Any advice on how to get the kernel/rc messages etc. to the serial > > console (only or as well)? > > > > Regards, > > Thomas > OK, so to rule out any installation-related problems, I booted from a > bootonly install CD (a May ~5th snapshot of 8.0-CURRENT), with "boot - > h -S115200". Same thing: bootloader stuff on the serial console, > kernel messages on the local computer only - and very slowly, at that, > I'd say about one line a second. You could very easily see the > characters being written to the screen. > > Am I the only one having these problems? It'd suck to buy a rather > expensive (probably because they're pretty rare these days, plus I had > to order from abroad) null modem cable and have it be completely > useless. > > Regards, > Thomas you need to set hint.uart.0.flags="0x10" dannyReceived on Wed Aug 26 2009 - 14:04:38 UTC
This archive was generated by hypermail 2.4.0 : Wed May 19 2021 - 11:39:54 UTC