Re: Can't get resume to work on -BETA1/-CURRENT-200906, help needed

Hi,

Gonzalo Nemmi wrote:
> log in
> acpiconf -s 3
> suspend works
> opened the lid and the screen doesn't come back (backlight never gets back)
> hard reset
> login again and checked /var/log/messages .. this is what I found:

I have problems with suspend too, on AMD64.  Basically it works and my 
systems comes back up, but some devices are hosed afterwards.

My bge network interface is one.  I get precisely the same PHY timeout 
errors you're getting after a suspend.

The iwn network driver screams the following if I try use it after a 
suspend:

> Jul  7 14:53:17 <kern.crit> fuzz kernel: iwn0: iwn_mem_lock: could not lock memory
> Jul  7 14:53:17 <kern.crit> fuzz last message repeated 7 times
> Jul  7 14:53:17 <kern.crit> fuzz kernel: iwn0: iwn_transfer_microcode: could not load boot firmware
> Jul  7 14:53:17 <kern.crit> fuzz kernel: iwn0: iwn_transfer_firmware: could not load boot firmware, error 60
> Jul  7 14:53:17 <kern.crit> fuzz kernel: iwn0: iwn_init_locked: could not load firmware, error 60


USB ports resume sometimes, sometimes not:

> Jul  7 14:58:44 <kern.crit> fuzz kernel: usbus2: port reset timeout
> Jul  7 14:58:44 <kern.crit> fuzz kernel: uhub_reattach_port:369: port 1 reset failed, error=USB_ERR_TIMEOUT
> Jul  7 14:58:44 <kern.crit> fuzz kernel: uhub_reattach_port:456: device problem (USB_ERR_TIMEOUT), disabling port 1
> Jul  7 14:58:44 <kern.crit> fuzz kernel: usbus6: port reset timeout
> Jul  7 14:58:44 <kern.crit> fuzz kernel: uhub_reattach_port:369: port 5 reset failed, error=USB_ERR_TIMEOUT
> Jul  7 14:58:44 <kern.crit> fuzz kernel: uhub_reattach_port:456: device problem (USB_ERR_TIMEOUT), disabling port 5
> Jul  7 14:58:55 <kern.crit> fuzz kernel: uhci_interrupt: resume detect
> Jul  7 14:58:55 <kern.crit> fuzz kernel: ugen6.2: <OmniVision Technologies, Inc. -> at usbus6 (disconnected)
> Jul  7 14:58:55 <kern.crit> fuzz kernel: ugen5.2: <STMicroelectronics> at usbus5 (disconnected)
> Jul  7 14:58:56 <kern.crit> fuzz kernel: usbus6: port reset timeout
> Jul  7 14:58:56 <kern.crit> fuzz kernel: uhub_reattach_port:369: port 6 reset failed, error=USB_ERR_TIMEOUT
> Jul  7 14:58:56 <kern.crit> fuzz kernel: uhub_reattach_port:456: device problem (USB_ERR_TIMEOUT), disabling port 6


And I just noticed this message:

> Jul  7 14:53:36 <kern.crit> fuzz kernel: calcru: runtime went backwards from 18237633 usec to 9377885 usec for pid 10 (idle)


Unloading modules from the kernel prior to suspending doesn't seem to 
work either.

On the upside, FreeBSD 8.0 boots rather quickly! :)


Regards,
Aragon