On 2014-09-23 02:13, Kurt Lidl wrote: > I downloaded the 10.1-BETA disc1 iso image for > sparc64, and burned it to media. I then used that > media to attempt an installation onto a spare > sparc64 machine that I have. > > Using UFS as the filesystem, and more or less just > following the prompts, the system got installed OK, > and boots off of ZFS OK. > > I then reinstalled onto a system that I manually > configured for ZFS. This installation fails to boot > from the hard disk, dying like this: > > ---- snip, snip ---- > ok reset > Res > LOM event: +487d+12h37m31s host reset > etting ... > > ? > Sun Fire V120 (UltraSPARC-IIe 648MHz), No Keyboard > OpenBoot 4.0, 4096 MB memory installed, Serial #53476432. > Ethernet address 0:3:ba:2f:fc:50, Host ID: 832ffc50. > > Boot device: disk0 File and args: > >>> FreeBSD/sparc64 ZFS boot block > Boot path: /pci_at_1f,0/pci_at_1/scsi_at_8/disk_at_0,0:a > Consoles: Open Firmware console > Memory Address not Aligned > ok > > ---- snip, snip ---- > > I have used my exact procedure in the past to install onto a ZFS > only sparc without issue. > > Has anyone else tried booting a ZFS only sparc64 installation > recently? > > -Kurt > _______________________________________________ > freebsd-current_at_freebsd.org mailing list > http://lists.freebsd.org/mailman/listinfo/freebsd-current > To unsubscribe, send any mail to "freebsd-current-unsubscribe_at_freebsd.org" > If you have the entire drive to spare, have you tried the 'ZFS auto mode' script that Devin and I wrote? It is the bottom option in the installer partitioning menu. -- Allan Jude
This archive was generated by hypermail 2.4.0 : Wed May 19 2021 - 11:40:52 UTC