On dg., jul. 21 2019, Cristian Pogolsha wrote: > Hi, > > Thank you for the instructions. I have a question related to > post-installation. My system doesn't boot after installing and > rebooting > the system. It just doesn't find the partition on the drive. I > get a blank > screen when selecting from the boot media list. What > partitioning scheme > did you use for your installation? Or is this problem > addressable with step > #2 in your instructions? Putting in the boot/loader.conf -> > set.hw.pci.mcfg=0? The **hw.pci.mcfg=0** line in /boot/loader.conf is so that your booting won't hang the same way it did on installation without manual parameters, shouldn't be related to your current issue. Remember to add the comment linking to the bug as well, so that you can remove it when those changes land in -CURRENT Also add yourself to the CC field in the bug, that way you can help test those changes. https://bugs.freebsd.org/bugzilla/show_bug.cgi?id=231760q Your current issue sounds like a problem with the way you installed / set up the system and is probably better for freebsd-questions: https://lists.freebsd.org/mailman/listinfo/freebsd-questions FWIW: I boot using EFI from ZFS in a geli-encrypted partition in a GPT disk, I recall some manual fiddling but those were likely because I needed sth particular. -- EvilhamReceived on Sun Jul 21 2019 - 14:34:08 UTC
This archive was generated by hypermail 2.4.0 : Wed May 19 2021 - 11:41:21 UTC