On Wed, Feb 03, 2021 at 06:40:50PM -0800, joe mcguckin wrote: > I went out and purchased a PCIe ethernet card - it uses the em driver. The system > boots and it is em0. > > It works fine in 100Mb mode, but in gigabit mode, it does not pass any traffic although ifconfig reports > the card as active and that it has negotiated 1000BTX full duplex. > > I have tried plugging both the igb and em cards into 2 different switches with the same result. When 13 was -current, I've had great experiences with em0 ethernet cards. I don't have a physical box with 14 at the moment. This one has been on 13 since 2020/10/26, the other one a while longer. em0: flags=8963<UP,BROADCAST,RUNNING,PROMISC,SIMPLEX,MULTICAST> metric 0 mtu 1500 options=4810099<RXCSUM,VLAN_MTU,VLAN_HWTAGGING,VLAN_HWCSUM,VLAN_HWFILTER,NOMAP> ether XXX inet XXX media: Ethernet autoselect (1000baseT <full-duplex>) status: active nd6 options=29<PERFORMNUD,IFDISABLED,AUTO_LINKLOCAL> Between two motherboards, I think I have 3 of them (1 on peripheral card), but the only one I can get at this minute identifies itself as: em0: <Intel(R) PRO/1000 Network Connection> mem 0xa3400000-0xa341ffff at device 31.6 on pci0 Never had an issue with any of my switches, although I seem to have mostly netgears at home.Received on Thu Feb 04 2021 - 03:25:19 UTC
This archive was generated by hypermail 2.4.0 : Wed May 19 2021 - 11:41:27 UTC