Kernel panic when using NEWCARD

Hi

Whenever I insert a non-cardbus pccard, kernel panics. It can panic
during startup just after "Timecounter tick every 10.000 msec" when
kernel founds my card or when the system already is up. Panic message is
the same. The OLDCARD driver works just fine after I disable CardBus
from bios.

Here is my dmesg:

Copyright (c) 1992-2003 The FreeBSD Project.
Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994
	The Regents of the University of California. All rights reserved.
FreeBSD 5.0-CURRENT #2: Thu May  1 20:17:42 EEST 2003
    maku_at_ogorod.dielocalwarez.com:/usr/src/sys/i386/compile/-=DLW=-
Preloaded elf kernel "/boot/kernel/kernel" at 0xc03d5000.
Preloaded elf module "/boot/kernel/if_ep.ko" at 0xc03d50a8.
Preloaded elf module "/boot/kernel/snd_mss.ko" at 0xc03d5154.
Preloaded elf module "/boot/kernel/snd_pcm.ko" at 0xc03d5200.
Timecounter "i8254"  frequency 1193182 Hz
CPU: Pentium/P55C (166.20-MHz 586-class CPU)
  Origin = "GenuineIntel"  Id = 0x544  Stepping = 4
  Features=0x8001bf<FPU,VME,DE,PSE,TSC,MSR,MCE,CX8,MMX>
real memory  = 84017152 (80 MB)
avail memory = 77393920 (73 MB)
Intel Pentium detected, installing workaround for F00F bug
VESA: v2.0, 2048k memory, flags:0x0, mode table:0xc033e4e0 (1000040)
VESA: CHIPS 65554 Super VGA
npx0: <math processor> on motherboard
npx0: INT 16 interface
pcibios: BIOS version 2.10
Using $PIR table, 2 entries at 0xc00fdc30
apm0: <APM BIOS> on motherboard
apm0: found APM BIOS v1.2, connected at v1.2
pcib0: <Host to PCI bridge> at pcibus 0 on motherboard
pci0: <PCI bus> on pcib0
cbb0: <ToPIC95B PCI-CardBus Bridge> irq 11 at device 2.0 on pci0
pccard0: <16-bit PCCard bus> on cbb0
cbb1: <ToPIC95B PCI-CardBus Bridge> irq 11 at device 2.1 on pci0
pccard1: <16-bit PCCard bus> on cbb1
pci0: <display, VGA> at device 4.0 (no driver attached)
isa0: <ISA bus> on motherboard
orm0: <Option ROM> at iomem 0xc0000-0xcbfff on isa0
pmtimer0 on isa0
ata0 at port 0x3f6,0x1f0-0x1f7 irq 14 on isa0
ata1 at port 0x376,0x170-0x177 irq 15 on isa0
atkbdc0: <Keyboard controller (i8042)> at port 0x64,0x60 on isa0
atkbd0: <AT Keyboard> flags 0x1 irq 1 on atkbdc0
psm0: <PS/2 Mouse> irq 12 on atkbdc0
psm0: model GlidePoint, device ID 0
fdc0: <NEC 765 or clone> at port 0x3f7,0x3f0-0x3f5 irq 6 drq 2 on isa0
pcic0 at port 0x3e0 iomem 0xd0000-0xd1fff irq 3 on isa0
pcic_attach: attach found no sockets
device_probe_and_attach: pcic0 attach returned 6
pcic1 at port 0x3e2 iomem 0xd4000-0xd5fff irq 4 on isa0
pcic_attach: attach found no sockets
device_probe_and_attach: pcic1 attach returned 6
sc0: <System console> at flags 0x100 on isa0
sc0: VGA <16 virtual consoles, flags=0x300>
sio0: configured irq 4 not in bitmap of probed irqs 0
sio0: port may not be enabled
sio0 at port 0x3f8-0x3ff irq 4 flags 0x10 on isa0
sio0: type 16550A
vga0: <Generic ISA VGA> at port 0x3c0-0x3df iomem 0xa0000-0xbffff on
isa0 speaker0: <PC speaker> at port 0x61 on isa0
unknown: <PNP0303> can't assign resources (port)
unknown: <TOS7400> can't assign resources (irq)
unknown: <PNP0700> can't assign resources (port)
unknown: <PNP0600> can't assign resources (port)
unknown: <PNP0600> can't assign resources (port)
unknown: <PNP0501> can't assign resources (port)
pcm0: <CS423x> at port 0x220-0x22f,0x388-0x38b,0x534-0x537 irq 5 drq 1,0
on isa0 Timecounters tick every 10.000 msec


Fatal trap 12: page fault while in kernel mode
fault virtual address	= 0xc6769000
fault code		= supervisor read, page not present
instruction pointer	= 0x8:0xc0143315
stack pointer	        = 0x10:0xc636a9d8
frame pointer	        = 0x10:0xc636abe8
code segment		= base 0x0, limit 0xfffff, type 0x1b
			= DPL 0, pres 1, def32 1, gran 1
processor eflags	= interrupt enabled, resume, IOPL = 0
current process		= 5 (cbb0)
trap number		= 12
panic: page fault

syncing disks, buffers remaining... 
done
Uptime: 1s
Automatic reboot in 15 seconds - press a key on the console to abort