Re: rpcbind signal6 on boot. no syslogd, no rc execution, etc.

From: Doug White <dwhite_at_gumbysoft.com>
Date: Thu, 15 Jan 2004 18:53:40 -0800 (PST)
On Wed, 14 Jan 2004, Edwin Culp wrote:

> Hardware:
> Dell PowerEdge 1600SC/XEON 2.4 1GB ram. ServerWorks
> BIOS

Hardware is in general known to be OK. Dunno about your specific instance
:)

First of all, hook up a serial console so you can capture the output.
Something is crying and we'd like to know what :)

Secondly, the applications you've listed could have been hit by the statfs
change. Are you following the instructions in UPDATING on how to upgrade
*exactly*?  Does rolling back to the previous kernel (kernel.old) get you
working again?

Third, don't rule out hardware failure.  Run the Dell diagnostics to make
sure you haven't toasted a CPU or something.  Check the system
temperature, check the fans, figure out what that blinking yellow light
means, etc.

-- 
Doug White                    |  FreeBSD: The Power to Serve
dwhite_at_gumbysoft.com          |  www.FreeBSD.org
Received on Thu Jan 15 2004 - 17:53:41 UTC

This archive was generated by hypermail 2.4.0 : Wed May 19 2021 - 11:37:38 UTC