Re: re0 fix that works with polling

From: John-Mark Gurney <gurney_j_at_resnet.uoregon.edu>
Date: Sun, 17 Oct 2004 18:12:35 -0700
John-Mark Gurney wrote this message on Sun, Oct 17, 2004 at 16:28 -0700:
> I'll do some tests shortly to see about these issues...

Ok, I played around w/ rwatson's netsend program, and I was able to
send 1316 byte payload udp packets at about 28kpps w/o problems.. I
was not able to confirm that no packets were loss, BUT, netstat did
show very close to 28kpps received...  At 28kpps, it's far exceeds
your problem of 15Mbps, it is about 38megbytes/sec..

What does your dmesg say about your re0?

Mine is:
re0: <RealTek 8169S Single-chip Gigabit Ethernet> port 0xe000-0xe0ff mem 0xe8002000-0xe80020ff irq 11 at device 11.0 on pci0
re0: Ethernet address: 00:50:fc:f7:5b:d0

and it's more specificly a 32-bit ConnectGear G30TX-32.

-- 
  John-Mark Gurney				Voice: +1 415 225 5579

     "All that I will do, has been done, All that I have, has not."
Received on Sun Oct 17 2004 - 23:12:37 UTC

This archive was generated by hypermail 2.4.0 : Wed May 19 2021 - 11:38:18 UTC