On Sat, Jul 14, 2007 at 12:30:05AM +0200, Gelsema, P (Patrick) - FreeBSD wrote: > I am running FreeBSD 7-Current-200706. Everything seems to be detected > during boot and all goes ok until the moment the message that the fxp0 > link state changed to up. After that moment the console output stops. I > cannot get to other tty;s or get output running again. > > However the machine is responsive and I can log on by SSH remotely and do > everything as if I were at the console. When I login by typing blind at > the console and issue the reboot command or when I press the power off > button on the workstation the console shows output again (not any use as > it is then rebooting or powering off). > > See http://www.superhero.nl/messages.txt for the message output during boot. > > Anyone seen this kind of behaviour? I've been seeing this intermittently on a relatively recent -current. It seems to have started when I added KDB/DDB to the kernel config, but I haven't disabled it yet to see for sure if that's the culprit. Mine is an SMP (dual-core) system if it makes any difference. It stops right after a 'bge0: link up' message. CraigReceived on Mon Jul 16 2007 - 13:39:09 UTC
This archive was generated by hypermail 2.4.0 : Wed May 19 2021 - 11:39:14 UTC