On Fri, Apr 04, 2008 at 12:24:26AM -0400, Tuc at T-B-O-H.NET wrote: > Hi, > > LONG LONG LONG story made short. > > Running Soekris 4801-60 previously on 5.5 . Would lock up > every so often, then more often, then finally constantly. Shipped > back to vendor, replaced, all good. Months later started to lock > every few weeks, then every few hours. Replace CF with hard drive, > locks in 10 minutes, etc. > > Load OpenBSD on disk. Runs for days with no problem. > Decide I don't like OpenBSD ports system so decide to go FreeBSD > 7. Glitch with memory stick, but otherwise system seems to run > fine. Start SETI, system locks HARD. I have it set to be able > to break to debugger with CR ~ ^b, but that just doesn't happen. > (Previously tested it would in single user when system running > fine). > > Is there any way to debug a kernel lockup if you CAN'T > break to debugger?? http://www.freebsd.org/doc/en_US.ISO8859-1/books/developers-handbook/kerneldebug.html Hope this helps. -- Rui PauloReceived on Fri Apr 04 2008 - 08:25:27 UTC
This archive was generated by hypermail 2.4.0 : Wed May 19 2021 - 11:39:29 UTC