Hello Ian FREISLICH wrote: > Hi > > When I run aaccli on 7-PRERELEASE, I get the following error: > > Adaptec SCSI RAID Controller Command Line Interface > Copyright 1998-2002 Adaptec, Inc. All rights reserved > -------------------------------------------------------------------------------- > > > CLI > open aac0 > Executing: open "aac0" > Command Error: <The miniport device driver is too old to work with the current A > FAAPI.DLL.> > > The device (2410SA) is detected as follows: > > hw.aac.iosize_max: 65536 > dev.aac.0.%desc: Adaptec SATA RAID 2410SA > dev.aac.0.%driver: aac > dev.aac.0.%location: slot=1 function=0 > dev.aac.0.%pnpinfo: vendor=0x9005 device=0x0285 subvendor=0x9005 subdevice=0x0290 class=0x010400 > dev.aac.0.%parent: pci6 > dev.aacd.0.%desc: RAID 1 (Mirror) > dev.aacd.0.%driver: aacd > dev.aacd.0.%parent: aac0 > > The system is amd64 SMP. The last kernel I have that works is > 7-CURRENT(i386) circa July last year. Does anyone know whether > amd64 is the issue, or whether the aac driver has just dropped > support for aaccli or if there is a newer aaccli available from > Adaptec? Or, has Adaptec just dropped FreeBSD support? Try ports/sysutils/arcconf. It should work with most adaptec controllers. Unfortantly you have to install adaptecs kernel module to use all feature with arcconf. I guess apdatecs kernel moduls are only available for 6.x (32/64bit). Regards, ThomasReceived on Tue Feb 12 2008 - 08:47:40 UTC
This archive was generated by hypermail 2.4.0 : Wed May 19 2021 - 11:39:27 UTC