Re: CFT: vr(4)

At 12:43 AM 2/22/2008, Pyun YongHyeon wrote:
>  >
>  > I've put up a new version under the old URL.
>  > It's not tested in sparc64 but it seems to work on i386.
>  > Would you give it spin?
>  >
>
>Any progress here? Does the updated one works on your box?


So far so good on my Soekris hardware. I will try some vlan tests tomorrow.

pci0: <encrypt/decrypt, entertainment crypto> at device 1.2 (no 
driver attached)
vr0: <VIA VT6105M Rhine III 10/100BaseTX> port 0xe100-0xe1ff mem 
0xa0004000-0xa00040ff irq 11 at device 6.0 on pci0
vr0: Quirks: 0x6
vr0: Revision: 0x96
miibus0: <MII bus> on vr0
ukphy0: <Generic IEEE 802.3u media interface> PHY 1 on miibus0
ukphy0:  10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto
vr0: Ethernet address: 00:00:24:c9:34:88
vr0: [ITHREAD]
vr1: <VIA VT6105M Rhine III 10/100BaseTX> port 0xe200-0xe2ff mem 
0xa0004100-0xa00041ff irq 5 at device 7.0 on pci0
vr1: Quirks: 0x6
vr1: Revision: 0x96
miibus1: <MII bus> on vr1
ukphy1: <Generic IEEE 802.3u media interface> PHY 1 on miibus1
ukphy1:  10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto
vr1: Ethernet address: 00:00:24:c9:34:89
vr1: [ITHREAD]
vr2: <VIA VT6105M Rhine III 10/100BaseTX> port 0xe300-0xe3ff mem 
0xa0004200-0xa00042ff irq 9 at device 8.0 on pci0
vr2: Quirks: 0x6
vr2: Revision: 0x96
miibus2: <MII bus> on vr2
ukphy2: <Generic IEEE 802.3u media interface> PHY 1 on miibus2
ukphy2:  10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto
vr2: Ethernet address: 00:00:24:c9:34:8a
vr2: [ITHREAD]
vr3: <VIA VT6105M Rhine III 10/100BaseTX> port 0xe400-0xe4ff mem 
0xa0004300-0xa00043ff irq 12 at device 9.0 on pci0
vr3: Quirks: 0x6
vr3: Revision: 0x96
miibus3: <MII bus> on vr3
ukphy3: <Generic IEEE 802.3u media interface> PHY 1 on miibus3
ukphy3:  10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto
vr3: Ethernet address: 00:00:24:c9:34:8b
vr3: [ITHREAD]

This is 7.0-PRERELEASE #0: Mon Feb 25 11:25:31 EST 2008

         ---Mike