Hi, wpaul. I got USB2.0 GbE Ether Adaptor a.k.a. PLANEX GU-1000T, but I can't use it by axe(4). So I tried to improve axe(4) driver, but I couldn't improve it:-(. Would you please fix this driver? - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - ehci0: <Intel 82801FB (ICH6) USB 2.0 controller> mem 0xb0040000-0xb00403ff irq 23 at device 29.7 on pci0 ehci0: [GIANT-LOCKED] ehci0: [ITHREAD] usb1: EHCI version 1.0 usb1: companion controller, 2 ports each: usb0 usb1: <Intel 82801FB (ICH6) USB 2.0 controller> on ehci0 usb1: USB revision 2.0 uhub1: <Intel EHCI root hub, class 9/0, rev 2.00/1.00, addr 1> on usb1 uhub1: 2 ports with 2 removable, self powered axe0: <vendor 0x0b95 product 0x1780, class 255/255, rev 2.00/0.01, addr 2> on uhub1 axe0: AX88178, bufsz 4096, boundary 512 miibus0: <MII bus> on axe0 ukphy0: <Generic IEEE 802.3u media interface> PHY 0 on miibus0 ukphy0: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, 1000baseSX, 1000baseT, 1000baseT-FDX, auto axe0: WARNING: using obsoleted if_watchdog interface axe0: WARNING: using obsoleted IFF_NEEDSGIANT flag axe0: Ethernet address: 00:90:cc:ef:b9:f6 - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - ISSUE: 1. after ether cable connected, axe(4) doesn't link up. 2. axe0 doesn't link up by 'ifconfig axe0 up', too. 3. so I couldn't communicate other machines. 4. I didn't know that axe(4) requires GIANT lock:-(. HAPPY: 1. MAC Address is correct. 2. I could replace obsolete if_watchdog interface. SEE ALSO: attached patches
This archive was generated by hypermail 2.4.0 : Wed May 19 2021 - 11:39:31 UTC