Same here: ugen2.2: <vendor 0x1005> at usbus2 (disconnected) umass0: at uhub2, port 5, addr 2 (disconnected) (da0:umass-sim0:0:0:0): lost device (da0:umass-sim0:0:0:0): removing device entry ugen2.2: <vendor 0x1005> at usbus2 umass0: <vendor 0x1005 USB FLASH DRIVE, class 0/0, rev 2.00/1.10, addr 2> on usbus2 umass0: SCSI over Bulk-Only; quirks = 0x0000 umass0:1:0:-1: Attached to scbus1 (probe0:umass-sim0:0:0:0): TEST UNIT READY. CDB: 0 0 0 0 0 0 (probe0:umass-sim0:0:0:0): CAM Status: SCSI Status Error (probe0:umass-sim0:0:0:0): SCSI Status: Check Condition (probe0:umass-sim0:0:0:0): UNIT ATTENTION asc:28,0 (probe0:umass-sim0:0:0:0): Not ready to ready change, medium may have changed (probe0:umass-sim0:0:0:0): Retrying Command (per Sense Data) da0 at umass-sim0 bus 0 target 0 lun 0 da0: < USB FLASH DRIVE PMAP> Removable Direct Access SCSI-0 device da0: 40.000MB/s transfers da0: 1968MB (4030464 512 byte sectors: 255H 63S/T 250C) # mount -t msdosfs /dev/da0 /mnt mount_msdosfs: /dev/da0: Invalid argument gg.Received on Fri Oct 02 2009 - 06:25:23 UTC
This archive was generated by hypermail 2.4.0 : Wed May 19 2021 - 11:39:56 UTC