On 04/03/14 12:06, Benjamin Kaduk wrote: > On Thu, 3 Apr 2014, David Wolfskill wrote: > >> And on my laptop, I had no problems (using AHCI). The build machine, >> though, starts OK, then comes to an inglorious end: >> >> Trying to mount root from ufs:/dev/aacd0s4a [rw]... >> mountroot: waiting for device /dev/aacd0s4a ... >> Mounting from ufs:/dev/aacd0s4a failed with error 19. >> > [...] >> >> mountroot> >> >> >> So... I have serial console access; is there any debugging I might >> do to help figure out what's wrong? Or is what's wrong already >> known? >> >> I have been able to reboot from this point to one of the other >> slices; I could probably also unload the default kernel & load >> yesterday's (err... make that "the day before's" -- yesterday's >> didn't build -- _at_r263983). > > I'm also having some trouble booting (into single user mode, so as to > run the installworld), at r264039. It seems that ciss never attaches, > so my da0 (which is supposed to be on ciss0) does not appear. My > kernel.old is much older, __FreeBSD_version 1100005, but does boot. > However, attempting to boot kernel.old in either single-user mode or > verbse mode also drops me to mountroot> . That would seem to indicate > some hardware problem or timing issues more than a problem with the code > itself, so I had been holding off on posting until I could get more > information. > > Unfortunately, my serial console is not working at the moment, so > getting more information is a bit challenging. Diffing the dmesg from > the good and bad boots would probably be helpful for you to do. > > -Ben I reported a similar problem on freebsd-current_at_ earlier today. Fortunately, my boot zpool is still fine, but a RocketRAID controller only shows 2/4 disks, which just happens to be a full leg of another raid10-like zpool. Try reverting revisions r264007-264013. This fixes the problem for me. - Nikolai LifanovReceived on Thu Apr 03 2014 - 14:14:44 UTC
This archive was generated by hypermail 2.4.0 : Wed May 19 2021 - 11:40:48 UTC